
A. Sleeve installation
1. Completely cover one end of the Ground Sleeve with a heavy
duty tape, such as duct tape.
2. Make a hole 12" deep with a diameter of 10". Following the
manufacturer's mixing instructions, ll the hole with wet
concrete.
3. While making sure the wet concrete does not enter the
Ground Sleeve, push the covered end of this sleeve into the wet
concrete.
4. The Ground Sleeve should be centered and ush with the
concrete. To help set the sleeve into place, use an object with
some weight to put on top of the sleeve while drying. Allow the
concrete to dry fully per the manufacturer's instructions.
ASSEMBLY INSTRUCTIONS
Adult Assembly and Supervision Required
Firm and
compact
soil
Concrete
10” Diameter
12”
Deep
Ground Sleeve
B. Pole Installation
1. Insert the Bottom Pole into the Ground Sleeve
2. Attach the Snap Clip with Tetherball to the Eyebolt at the
top of the Top Pole.
3. Insert the Top Pole onto the Bottom Pole until the button
locks in place. Adjust the length of the tether so that the ball
hangs approximately two feet from the ground.
Note: Store equipment indoors after use. Do not hang from
or pull on the pole to avoid damages to the equipment.
Ground Sleeve
Bottom Pole
Snap Clip
Eyebolt
Top Pole
Bottom Pole
C. Play Zone Setup
The court should be set up as a circle 20 feet in diameter.
Divide the circle as follows:
Playing Zone
Playing Zone
Neutral Zone Neutral Zone