stilum Jump circleL User manual

© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. [phone] • All rights and product modications reserved. State: 25.01.2019 S. 1
Mounting instructions bouncing element „jump circleL“
Item no. 51461x240
Diagram 1: Overall view of the play equipment
Edit: 25.01.2019
Bouncing element Jump Circle L
Art. 013240
Installation and maintenance manual

© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. [phone] • All rights and product modications reserved. State: 25.01.2019 S. 2
Mounting instructions bouncing element „jump circleL“
Item no. 51461x240
Diagram 2: Combined frost protection and load bearing layer
Diagram 3: Cut through installed Bouncing Element Jump Circle L
1. Select the play equipment location in consideration of the required safety
area (see diagram 4: Ø 5900 mm).
2. Carry out excavation work for the foundation anchor as shown in diagram 3.
pit size: Ø 2600 x 600 mm
excavation of the pit: 3,186 m³
Needed combined frost protection and load bearing layer material: 0,878 m³
Note: Lifting equipment is needed
3. Create combined frost protection and load bearing layer as shown in dia-
gram 2.
4. Screw the eyebolts into the existing holes and use as lifting point.
5. Lifting Bouncing Element Jump Circle L and place it in the middle of the pit.
6. Unscrew eyebolts
7. Fill the gap with parts of excavation
8. Think about safety surface
9. For a maximum fall height of 1000 mm safety surface must be according to
EN 1176-1, chart 4.
For a bouncing element, the extent of the clearance must be 2000 mm hori-
zontally around the jump surface, measured at each point of the edge, and
3500 mm above the jump surface.
10. Do not allow children to use the equipment before the installation has been
nished.
Attention: If the play equipment has been incompletely installed or partly
dismantled when carrying out maintenance and repair work, this may lead to
particular risks of injury for the user. For this reason, make clearly visible that the
equipment shall not be used in such cases.
5
Drawing 2: Combined frost protection and load bearing layer
6
Drawing 3: Cut through installed Bouncing Element Jump Circle L

© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. [phone] • All rights and product modications reserved. State: 25.01.2019 S. 3
Mounting instructions bouncing element „jump circleL“
Item no. 51461x240
4
4. Dimensions
Drawing 1: Dimensions impact area
For a bouncing element, the extent of the clearance must be
2000 mm horizontally around the jump surface, measured at
each point of the edge, and 3500 mm above the jump surface.
Impact area
Ø5900 mm
Diagram 4: Top view
Extent of the minimum zone =
safety area