Stoov Charge6 User manual

Assembly instructions
Charge6

EN | Product information
WARNING: Read carefully before use
• Only use the AC adapter enclosed with your Stoov®
products. Using a dierent charger may cause irre-
placeble damage to the product and can be danger-
ous.
• Do not expose the product to excessive heat from
other sources.
• Do not use if wet
• Examine the electrical cords frequently for signs of
weakness or damage. If there are such signs, please
replace these parts.

What’s included?
• Metal frame
• Metal inlay tray
• Wooden board
• Power strip
Assembly instructions
Step 1
Place the large strain reliever around the wire of the
power strip. And place the strain reliever with the wire on
the metal inlay tray. See illustration for the position of the
power strip and the large strain reliever.
• 1x large strain reliever
• 6x small strain reliever
• 4x nylon washers
• 4x wood screws

Step 2
Place the 6 smaller strain relievers around 6 power cords
of your Stoov® chargers.
Place the cords with the strain reliever on the metal tray.
We advice to place to strain reliever 25cm from the end
of the wire.

Step 3
Tie up the extra length of the cords with a tie-wrap or an
elastic. And place the chargers in the sockets of the pow-
er strip. See image on the previous page for the position
of the chargers.
Step 4
Now place back the metal tray in the frame with the pow-
er strip and all the chargers.
Step 5
Place 4 round black nylon washers on the tray above the
holes. See image below on where to place the washers.

Step 6
Place the wooden board on top of the washers and the
tray. Screw the wooden board to the tray and metal frame
with the 4 wood screws.See image below to see how to
place the wooden screws.

Stoov B.V.
Rembrandtlaan 14a
3723 BJ Bilthoven
The Netherlands
[phone]
[email protected]
@mystoov
www.stoov.com