Store More Store JumpSeat 90 User manual

Parts Included
Tools Required
Seat
Hardware Included
1/4“
Masonry
Drill Bit
Power Drill
7/16” Nut Driver
(Concrete)
1/4“
Standard
Drill Bit
1/4”x3”
Concrete Anchors
5/32”
Allen Wrench
Concrete
Anchor Caps
12
3
3/8”x2”
Lag Screw
Lag Screw
Caps
4
5
9/16” Nut Driver
(Wood)
Fixed Base
Movable Base
JumpSeat 90

Floor Installation
Concrete
Position the base on the floor and mark the hole
locations.
Drill 3/16” pilot holes appox. 2” deep.
Use Concrete Anchors to attach base to floor.
Loosen the bolts on the lower front panel with an Allen
Wrench.
Slide Jumpseat over the mounting base until it makes
contact with the base plate.
Tighten the bolts with the supplied Allen Wrench.
3
1
Position the base on the floor and mark the hole
locations.
Drill 3/16” pilot holes.
Use Lag Screws to attach base to floor.
2
4
5
Wood
JumpSeat 90

Tighten the bolts on the lower front panel with the
supplied Allen Wrench.
Loosen the bolts on the lower front panel with an Allen
Wrench.
Slide Jumpseat over the mounting base until it makes
contact with the base plate.
5
Movable Base Assembly
JumpSeat 90