Streacom TL1 User manual
Page
2................. Index, Foreword
3................. Product Overview
4................. Unpack and Position
5................. Connecting the TL1
6................. General Operation
Foreword
Thank you for your purchase of this Streacom product. Every care has been taken to
ensure that it meets with the highest quality and standards that we have set for
ourselves.
Should you have any questions that are not covered in this user guide, support can be
offered via email through our website at www.streacom.com
We sincerely hope that you enjoy using our product!
P2 - INDEX
Key Features
1.... L Channel Vacuum Tubes 4.... Input Jacks 7.... AC Power Socket
2.... Volume Control 5.... R Channel Output Jacks 8.... Fuse Holder
3.... R Channel Vacuum Tubes 6.... L Channel Output Jacks 9.... Power Switch
2
Specification
Valve Tube Model 6F3
Power Output 2.5W + 2.5W @ 8 Ohms
Frequency Response 800Mv
Residual Noise < 0.6 mV AC
Input Voltage 100 - 240V AC Standard IEC Jack with fuse protection (2A)
Power Consumption 33W
Input Impedance 10K Ohms
Output Impedance 16/8/6/4 Ohms
Dimensions 132 × 96 × 100mm (W×D×H)
Input Connector Type RCA Jacks
Output Connector Type Banana Jacks
Weight 1.7Kg
OVERVIEW - P3
137 8 965
4
Unpack and Position
Carefully remove the amplified from the box and protective packing, ensuring not to damage the
vacuum tubes.
P4 - UNPACK AND POSITION
With the amplifier unpacked, check the vacuum tubes have not been damaged and are properly
installed into the sockets.
You can now place the TL1 in the appropriate location near your audio source.
CONNECTING THE TL1 - P5
Connecting the TL1
Speakers - Connect the ‘-’ terminal of your speakers to the 0Ω terminal of the amplifier. Depending
on your speaker impedance, connect the ‘+’ terminal to either the 4, 6 or 8Ω terminal of the amplifier.
Note - Only 1 black and 1 red terminal from each side should be connected.
0Ω
8Ω
6Ω4Ω
0Ω8Ω
6Ω
4Ω
Audio Source - Connect the amplifier to your audio source e.g. the line out from your HTPC
Power - Finally connect the amplifier to the mains electricity socket, 100-240 VAC
Right
Speaker
Left
Speaker
Audio
Source
Mains
Power
R L
GENERAL OPERATION - P6
Turning on the TL1
The power switch is located on the back of the
TL1. To turn on the amplifier, simply push the
switch downwards to position ‘1'. To turn off the
amplifier, push the switch to position ‘0'
- +
Controlling the Volume
To adjust the volume, turn the volume knob clockwise to increase and anti-clockwise to reduce.
General Precautions
Do not operate or store the TL1 in damp conditions.
Never operate the TL1 without speakers connected, doing so can cause permanent damage.
There are no user serviceable parts inside the amplifier and it should only be opened by a qualified
service engineer.
Melbournestraat 56,
3047 BJ Rotterdam,
The Netherlands
www.streacom.com V1.12.02
