StreetEagle VTU User manual
GPS Vehicle Tracking Unit
Installation Guide
Note to Installer - Please return
these instructions to customer
for future reference
Installation Support:
866-658-1191
Precautions
12v DC Power only.
The Vehicle Tracking Unit (VTU) is designed for
negative ground 12V DC systems only. Do not use the
VTU with any other power systems.
Do not disassemble or modify the VTU.
This could cause electric shock, personal injury or fire.
Do not connect power from a different system to the
VTU. When in doubt of a safe installation, please
contact your local installer.
Do not install VTU in locations that interfere with
airbag operation.
This could cause a risk of accidents and injury.
Use only specified fuse.
When replacing the fuse, please ensure the amp rating
is the same as the previous fuse.
Cautions
Do not let wires get punctured by screws or caught in
moving parts.
Turn car ignition off before making connections.
Connect the Red and White power input leads after all
other connections have been made.
Use a common ground point for all ground wires.
Tape and insulate any loose unconnected wires.
Note on power wire (Red)
When connecting VTU in combination with other electric
devices, be sure the vehicles’ circuit amp rating is higher
than the sum of each component’s fuse.
This installation guide provides detailed instructions for
installing the StreetEagle Vehicle Tracking Unit (VTU).
These instructions must be followed precisely to insure
correct operation of the GPS Tracking unit and to ensure
warranty coverage of the equipment. Please call
StreetEagle Support at (866)658-1191 if you require
assistance.
GPS Tracking Kit Equipment
•StreetEagle VTU
•Wiring harness
•Installation Instructions and Activation Guide
Required Tools and Supplies
•Crimpers and the appropriate connectors
•Fuse taps
•Drill with screwdriver and bit attachments
•Cable ties or self-adhesive tie mounts
Installation Procedures
1. Record the IMEI number - This 15-digit number is
located on the bottom of the tracking unit and also found on
the activation guide. You will need this for testing.
2. Find a suitable location and mount the VTU –
The VTU should be mounted in the dash, unobstructed by
metal and with a direct line of sight to the sky. Please
ensure that the VTU’s GPS Side is facing the sky. This
is marked by a sticker on the VTU, showing “GPS THIS
SIDE UP”.
3. Connect the Wires to the Vehicle - Use the wiring
harness provided with the installation kit. DO NOT PLUG
THE POWER CABLE INTO THE VTU AT THIS TIME!!
Connect the wires according to the following table:
* See Wiring Diagram for details
4. Optional Connections - Connect GREEN input
for notification of vehicle alarm activation. Connect BLUE
output connection for remote door unlock. Connect the
YELLOW output connection for starter disable. Connect
the PURPLE input for Driver security alert. Note that the
output signals are active ground and the input signals
are active high (+12V). Relays may be required for
correct operation. See Wiring Diagram for more details.
5. Connect the power cable to the VTU - with the
ignition off, attach the power cable to the VTU. The
retaining clip will snap into place when the connector is
properly seated.
Black Ground
White Ignition (Accessory) →12v is supplied only when ignition is on
Red Battery →12v is supplied constantly, regardless of ignition state
Green Optional alarm monitor*
Yellow Optional ignition disable*
Blue Optional door unlock*
Purple Optional Driver Security Alert*
6. Check Unit Operation
1-ORANGE - Turns solid once the unit acquires a
cellular signal. If this light is continuously blinking check
for proper installation of the VTU and be sure the data
account is active.
2-GREEN - Turns solid once the unit acquires a GPS
signal. If this light is continuously blinking verify proper
VTU mounting and that the “GPS THIS SIDE UP” is
facing the sky.
After all of the lights are solid turn the vehicle off, then
turn it back on and verify the installation.
Note: When the VTU is installed, it can take up to 20
minutes for the GPS to acquire its position after initial
power-up. Subsequent position acquisition will be less
than 30 seconds of the vehicle start-up.
1 2
How To Verify Correct Installation
1. Log on to http://install.insightmobiledata.com.
This website will allow you to test the installation of the
Vehicle Tracking Unit.
2. Enter the 15-digit IMEI number from the Vehicle
tracking unit in the space provided. The IMEI number
can also be found on a sticker located on the first page
of the customer Activation Guide.
3. Once the IMEI number has been entered you will be
brought to the vehicle status and testing screen.
The vehicle status screen will allow you to test proper
installation and function of you Vehicle tracking unit
though the following options.
Current GPS Status – The most recent report from the
tracking unit
Location Address – shows an approximate address of
the vehicle’s current GPS location.
Refresh Status – Refresh the screen to show the most
recent location report.
Ping – Requests for the tracking unit to send its current
location and status.
Enable Ignition – Enables Starter if optional starter
disable equipment is installed.
Disable Ignition- Disables Starter if optional starter
disable equipment is installed.
Unlock Door – Unlocks door if optional door unlock
circuit has been installed.
Troubleshooting
The StreetEagle GPS tracking unit has 2 LEDs on the
front of the unit that indicates proper operation:
Orange - Blinks then turns solid when cell signal is
acquired.
Green – Blinks then turns solid when GPS signal is
acquired.
Both lights should be lit solid during proper operation
when the vehicles ignition is on and vehicle is in an area
with a clear view of the sky and good cellular coverage.
Problem – LED’s not on.
Solution - The unit is not getting constant (battery)
power.
Problem – Orange LED is blinking, no cell signal.
Solution - Check for proper installation of the unit.
Problem - Green LED is not on, no GPS signal.
Solution - Verify proper installation of unit; verify that the
VTU has a clear view of the sky, with the proper side up
facing the sky.
Table of contents
