Summit Professional FFBF181SS User manual

Instructions for use
Upright refrigerator - freezer
Model FFBF181SS

253479
Thank you for your confidence in buying our appliance and congratulations on the excellent choice.
We hope it will successfully serve its purpose for many years.
The appliance is intended solely for household use.
Upright refrigerator - freezer (hereinafter: the appliance) composed of two parts: the upper
compartment is a refrigerator and the lower compartment is a freezer.
Refrigerator is used for the storage of fresh foods at temperatures above 32°F.
Freezer is used for freezing fresh foods and the storage of frozen foods for up to one year
(depending on the type of food).
2
IMPORTANT SAFEGUARDS ....................................... 3
Before your first use ................................................... 4
Description of the appliance ...................................... 5
Installation and connection........................................ 6
Reverse door swing .................................................. 8
Control panel - appliance
with electronic regulation........................................... 9
Recommended distribution of food ........................ 12
Storing fresh food ................................................... 13
Freezing and storage of frozen food ....................... 14
Defrosting the appliance........................................... 16
Cleaning ..................................................................... 17
Troubleshooting guide.............................................. 18
Noise level.................................................................. 19
Limited Warranty ....................................................... 20

253479
• Before connecting the appliance, read these instructions carefully.
• The appliance is manufactured in compliance with all relevant safety standards; however, it is
recommended that persons with impaired physical, emotional, or mental abilities, or persons with
inadequate experience and knowledge, do not use the appliance without due supervision. The
same recommendation applies to minors using the appliance. Cleaning and user maintenance
should not be done by children without supervision.
• The appliance must be connected to the electrical supply in accordance with the standing
regulations and local requirements.
• The appliance must not be used in open air or exposed to rain or other precipitation.
• Always disconnect the appliance from the power supply (pull the power cord from wall socket)
before cleaning and before replacing the light bulb.
• If the power supply cord is damaged, in order to avoid hazard it must be replaced only by
qualified personnel.
• In the event of long periods without use, switch off the appliance with the ON/OFF button and
disconnect it from the wall socket. Empty the appliance, clean the interior and leave the door
ajar.
• For the protection of the environment, please contact local authorities for correct disposal
arrangements.
• Never let children play with the appliance.
• DANGER: Risk of child entrapment! Before you throw away your old refrigerator or freezer: take off the
doors and leave the shelves in place so that children may not easily climb inside.
• Warning: Ventilation slots on the appliance or built-in element should always be kept clean and
unobstructed.
• Warning: Do not use any mechanical accessories when thawing the refrigerator, except for
those explicitly recommended by the manufacturer.
• Warning: To prevent any pollution be careful not to damage the insulation or refrigeration tubes
at the rear wall during the installation, cleaning and disposal of the appliance.
• Warning: Do not use any electrical devices inside the appliance, except for those explicitly
recommended by the manufacturer.
This symbol on the product or on its packaging indicates that this product should
not be treated as household waste. Instead it should be handed over to the
applicable collection point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of this product. For more
detailed information about recycling this product, please contact your local city
office, your household waste disposal service or your place of purchase.
– Save these instructions –
3
IMPORTANT SAFEGUARDS

253479
• Before connecting the appliance, read these instructions carefully. They describe the appliance
and provide instructions for its safe and correct use.
• Remove the wrapping protecting the appliance during transport.
• Door corners are fitted with protective spacers. Remove the spacers and replace them with the
attached pegs.
• Before connecting the appliance to the electrical supply, leave it in the upright position for about
2 hours. This will reduce the possibility of malfunctions in the cooling system resulting from prior
transport and handling.
• The packaging of this appliance contains environmentally friendly materials which can be
recycled, recovered or disposed of without threat to the environment.
• A rating plate with basic information is located in the interior of the appliance.
4
Before your first use

253479
A Refrigerator
1Control panel
2Interior light
3Fan
4Shelf (adjustable height)
5Foldable egg tray
(closed 6, open 12 eggs)
6Bottle rack
7Crisper
8Door trays (options: deep,
shallow, cover or no cover)
9Bottle tray with holder
B Freezer
10 Storage drawer
11 Freezer drawer
12 Leg
13 Wheel
• Interior accessories may vary according to the model.
• Drawers are protected against accidental extraction. To remove the drawer from the appliance,
open it and lift front part upwards, then pull it out.
A
B
1
3
4
5
6
7
8
9
11
10
13
12
2
10
5
Description of the appliance

253479
• Place the appliance in a dry and well-aired room. Ambient
temperature should never be lower than 41°F.
Positioning the appliance requires two persons in order to avoid
injuries or damage to the appliance.
• Place the appliance flat and firmly on a solid base. The
appliance is fitted with adjustable feet on the front side, used
to level the appliance. The rear side of the appliance is fitted
with wheels facilitating the positioning of the appliance at the
preselected place.
• Allow at least 2 inches of space above the appliance to ensure
sufficient cooling of the condenser.
• Avoid exposing the appliance to direct sunlight or heat
sources. If this is not possible, install an insulation plate
between the appliance and the adjacent heat source.
• The bottom front corners of the appliance are fitted with
handles to facilitate moving. The appliance may stand
independently or adjacent to a wall, cabinet or other appiance.
Be sure to leave enough space for the opening of the door, to
avoid damage to the appliance or personal injury. Also leave
ample space for removing shelves (see installation diagram).
• Two spacers attached to the appliance must be fitted onto the
upper edge of the condenser, thus preventing the appliance
from being installed too close to the wall.
Selecting the location
Positioning the
appliance
6
Installation and connection

253479
• Use the power cord to connect the appliance to the electrical
power. The wall outlet must be fitted with a ground terminal
(safety socket).
The use of an extension cord is not recommended.
Nominal voltage and frequency are indicated on the relevant
label or rating plate on the appliance.
• The electrical power connection and grounding must be in
accordance with standing regulations and local requirements.
The appliance is able to accommodate minor temporary voltage
fluctuations that do not exceed ±6%.
Connecting to power
supply
Min 25.6”
Min 25.6”
Min 34.7”
Min 45.7”
7

253479
Required tools: socket wrench no. 8, screwdriver, torx 25.
Caution! After unscrewing or before fixing hinges, hold the door
to prevent it from falling and being damaged.
1. Remove upper hinge cover (save it for later use). Also remove
the cover on the opposite side of the upper hinge cover (you
will insert the attached cover on the other side during the
assembly).
2. Unscrew upper hinge screws and remove the upper door from
the middle hinge.
3. On the lower edge of the upper door unscrew the swing
stopper screws and remove the stopper (A). Keep this for
eventual use later on. Fix the attached stopper with its
bearing on the opposite side of the door.
4. Unscrew the forced door closure system (B) and fix it to the
opposite side of the door (certain models only).
5. Unscrew middle hinge screws, remove the door from bottom
hinge.
6. Loosen the screws fixing the leg supports (certain models
only), then continue with either procedure 7 or 7.1 below,
depending on the model of the appliance.
7. Tilt the appliance backward (max. 35°) and let it rest against
a firm support. Unscrew the leg support screws (C) - left and
right, and remove the leg support cover (D) and place it on
the opposite side. Unscrew and remove, then reverse the
positions of end switch (E) and decorative peg (F).
(For models with a forced door closing system, undo the three
screws attaching the lower hinge and install the hinge on the
opposite side.)
7.1.Tilt the appliance backwards (max. 35°) and let it rest against
a firm support at the back.
Undo the three screws attaching the lower hinge and install
the hinge on the opposite side. Plug the holes left after this
installation with the appropriate pegs.
8. Repeat procedures 3 and 4 on the bottom door. In case there
is no bottom door limit peg, transfer the bearing (G) and
washer to the opposite side of the door.
9. Proceed with the assembly procedure in opposite sequence.
8
Reverse door swing

253479
No- frost system appliance
A Freezer ON/OFF button
B Green signal lamp: indicates freezer operation
C Refrigerator ON/OFF button
D Green signal lamp: indicates refrigerator operation
E Intensive freezing ON/OFF button
F Orange signal lamp: intensive freezing in operation
G Intensive cooling ON/OFF button
H Orange signal lamp: intensive cooling in operation
I Sound alarm and child lock ON/OFF button
J Red signal lamp: alarm is active
K Temperature setting buttons
L Digital display indicating current temperature in the refrigerator or the set refrigerator or
freezer temperature: refrigerator temperature from 34°F to 48°F, freezer temperature from 7°F
to -9°F
M Temperature setting button: for refrigerator or freezer temperature
N Digital display indicating the selection of temperature setting for either refrigerator or
freezer: F – for freezer, R – for refrigerator
9
CONTROL UNIT
Control panel - appliance with electronic regulation

253479
Before the first use of the appliance first plug the power cable
into the wall socket. Display indicates dashes for both the
refrigerator and the freezer.
- Switch the appliance ON by pressing the button Afor 3
seconds. Both the refrigerator and the freezer are started,
green signal lamps Band Dare on. In this mode you can
switch off the refrigerator only by pressing button Cfor 3
seconds (green signal lamp Dis off).
- Refrigerator temperature of + 48°F is indicated on the display.
This value will remain on the display until the temperature in
the refrigerator drops below this level.
The appliance has been preset in the factory to the
recommended temperatures of the refrigerator to +41°F and
freezer to 0°F.
Temperature setting range of the refrigerator: +34°F do
+48°F.
Temperature setting range of the freezer: 7°F do -9°F.
• To set the freezer temperature, first select the freezer by
pressing the Mbutton (letter “F” will be indicated on the display
N); then, use the Kbutton to set the desired temperature.
To set the refrigerator temperature, first select the refrigerator
by pressing the Mbutton (letter “R” will be indicated on
the display N); then, use the K buttons to set the desired
temperature.
• After pressing the temperature setting buttons the display
starts flashing and indicates the last selected setting.
• Temperature setting is changed by short consecutive pressing
of the button in 1°F steps. During the setting procedure all
other buttons are idle.
• Approximately 5 seconds after the setting button is released
the display indicates the actual temperature.
Alarm
Continuous sound - open refrigerator door alarm
If the refrigerator door is open for more than one minute, the
sound alarm is turned on (continuous tone) and red signal lamp
Jis on. The alarm is automatically switched off when the door is
closed, but you can also switch it off by pressing the Alarm Off
button (I).
Intermittent sound - freezer/refrigerator temperature is too
high
Sound alarm is also activated in case of elevated temperature
(intermittent tone), and the temperature on the display is flashing.
Switching the appliance
ON/OFF
Temperature setting
Other settings
10