Sun Microsystems Fire V210 User manual

Power
Ethernet Ports
Serial Ports
See the Sun Fire V210 and V240 Server
Installation Guide for more details.
See the Sun Fire V210 and V240 Server
Installation Guide for more details.
Sun Fire V240 Server
Input Parameter
SERIAL MGT : RJ-45 connector, use this port for server
management using the ALOM software.
10101: DB-9 connector, use this port for general purpose
serial data transfer.
NET MGT: RJ-45 connector, 4 use this port for making an
Ethernet connection to the ALOM software.
NET 0-3: autonegotiating 10/100/1000Base-T
AC Inlet
Voltage (RMS)
Frequency
90V to 264V
47 Hz to 63 Hz
Front Panel
Hard disk driveHard disk drive
Front bezelFront bezel
On / Standby switchOn / Standby switch
System keyswitchSystem keyswitch
DVD-ROM driveDVD-ROM drive
Sun Fire V240 Server
5
5
System
configuration
card
System
configuration
card
Open bezelOpen bezel
4
LocatorLocator
Service required
Server active
Sun Fire V210 Server
3Attach the Cables
Sun Fire V210 Server
Server Power On and Operation
6
1. Set up a console connection to the server
using the server's SERIAL MGT port.
2. Power on either from the keyboard or by
using the On/Standby switch.
Note: the server goes into Standby power
mode as soon as the power cable is connected
to the power inlet.
See the Sun Fire V210 and V240 Server
Installation Guide for more details.
LockedLocked
Forced
standby
Forced
NormalNormal
DiagnosticsDiagnostics
Ensure keyswitch is in Normal ( ) position
before continuing (Sun Fire V210 Server does
not have a keyswitch).
Sun Fire V240 Server
Keyswitch Positions
USB
NET 0-3
10101
Open bezelOpen bezel
10101 SCSI
Hard disk driveHard disk drive
Front bezelFront bezel System
configuration
card
System
configuration
card
On / Standby switchOn / Standby switch
DVD-ROM driveDVD-ROM drive
SERIAL MGT
NET MGT
Power inlet
USB
NET 0-3
SCSI
Power inlet NET MGT
SERIAL MGT
LocatorLocator
Service required
Server active
Fold
Fold Fold
Fold Fold
Fold