Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
Figure 2
ACD
B
Instructions for First Time Use
1. The ON/OFF switch is preset to OFF position from factory. Put switch in the ON position and
allow solar light to charge for at least 8 hours in full sunlight.
2 After solar light is fully charged, turn light switch to ON position.
Where to Place the Solar Light
1. Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day.
2. Do not place the solar light near other outdoor lighting like porch or streetlight. Other light
sources may fool the sensor and keep the light from coming on, or cause it to
turn off automatically.
NOTE: The number of hours light is illuminated is directly proportional to the
number of hours of sunlight it receives. If the solar light is place in a shaded
area it will not fully charge and reduce the hours of nighttime light.
Care Instructions
1. Clean dirt and debris from solar panels. Panels cannot recharge if light is obstructed. Use a soft
cloth to clean panels.
2. Do not use abrasive or chemicals that might scratch or damage the UV coating.
3. In a regions where solar panel is covered with ice and snow for an extended period of time, the
batteries will require recharge for at least 8 hours.
Solar Panel
12
Power
Switch
Battery
Recycling
Ambient temperature maximum 40°C (105°F)
Protect batteries
against heat and firerisk of explosion
Do not dispose of batteries in
household waste
Do not throw batteries into water
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
A Flamingo 1
B Solar Pole Section 1
C Lower Pole Section 1
D Ground Stake 1
Parts Detail
D
Recycling
Please dispose of batteries properly. Consult
your local telephone listings for a battery
recycling center in your area.
1. (SEE FIGURE 1) Attach the solar pole section (B) to
the lower pole section (C), pushing firmly.
2. Attach the ground stake (D) to the lower pole
section (C), pushing firmly.
3. Place the flamingo (A) over the light on the solar
pole section (B) and rotate until the leg is placed
appropriately to the body.
CAUTION: In compacted, clay or hard soils,
moisten the ground with water before
inserting the ground stake to avoid breakage.
Battery Replacement
The rechargeable batteries in your solar light come
preinstalled from the factory.
1. (SEE FIGURE 2) Turn switch on solar panel to
the OFF position.
2. Unscrew small screws on the back of the solar
panel. Gently expose the inside of the solar panel
unit, using care to not disconnect the wires.
3. Remove the battery and replace with a battery of
same rating. Refer to (+/-) polarity markings in
the battery compartment for proper installation.
4. Reassemble the solar panel and turn switch to the
ON position.
5. Refer to the section “Instructions for First Time
Use” to restore the new battery to full charge.
Figure 1
B
D
C
A
OFFON
OFFON
