1. Place the clamp in place as shown
and tighten the pin.
2. Hold the light pole as shown and
tighten the side pin.
3. Properly connect power cord, adjust
the lighting angle then to use.
SUN-FLEX®DESKLITE
Installation Details
Remote control
Hose can be bent according to the
actual lighting needs, but not
excessive distortion, excessive
distortion will cause the hose
deformation, restore Complex to less
than the original, affecting the service
life.
switch
Brightness adjustment
(five stagess)
20%、40%、50%、
65%、100%
Color temperature
adjustment (five stages)
3000K-6500K
Infrared sensor head
10 minutes delay indicator
60 seconds delay indicator
power
color
bright
Precautions
This operation is not correct, please install and
use the correct way.
×
1
Please use the product delivery power adapter.
When adjusting the angle, do not over-bend the hose to avoid damaging the hose.
Lamps only for indoor use.
Do not use this product on the surface of high temperature, flammable objects or
in humid environment to avoid damage or short road.
Do not disassemble the lamp by yourself to avoid unnecessary loss.
The lamp light source is irreplaceable; when the light source to its end of life, the
entire lamp should be replaced.
Clamp folder the thickness of the material is recommended within 30mm, on the
contrary will result in a fixed lamp is not strong.
Clip mouth surface to be flat, on the contrary will result in fixed lighting is not
strong.
( ): Indicator light
(ON): Switch
(10M): 10 minutes delay turn off the light
(Bright +): Increase the brightness
(Bright -): Reduce the brightness
(color +): Increase the color temperature
(color -): Reduce color temperature
( ): night light function
(20%): Brightness 20%
(100%): brightness 100%
(Mix):the middle color temperature
(Warm): warm light
(Cool): white light
Color-
Bright+
Color+
Bright-
ON 10M
20%
Mix
100%
Warm Cool
