SUNMED 7600 User manual

800-433-2797 www.Sun-Med.com
User Guide 7600 Bubble Humidier Home Use
The 7600 Bubble Humidier is a disposable, single-patient use device for
use in health care facilities and home care. The humidier is used to provide
additional humidity to oxygen therapy for ow rates at 3 to 7 liters per minute
(LPM). The Bubble Humidier has a 6 PSI safety pop-o valve, which sounds
and releases excess pressure if the oxygen tubing becomes blocked.
Product Use
1. Wash your hands and remove the Bubble Humidier from packaging.
2. Use sterile, distilled or boiled tap water. If using boiled tap water, cool water
to room temperature before adding to the Bubble Humidier.
3. Unscrew the lid and add water to the maximum level marking (290 mL)
located on the side of the bottle.
4. Replace the lid. Ensure that the threads are properly aligned and
that the lid is screwed on tight.
5. Attach the Bubble Humidier to an oxygen source, e.g. owmeter, oxygen
concentrator or liquid tank.
6. Test for leaks. Turn the ow to 3 LPM and block the oxygen outlet port on the
Bubble Humidier (A). A sound should emit within 5 seconds. If there is no
sound, check the lid and other connections for leaks. Repeat the leak test.
7. Attach the oxygen supply tubing for your nasal cannula or oxygen mask (B)
and adjust oxygen ow to the prescribed setting.
8. Check for bubbles in the water. If there are no bubbles check
for leaks. If the device sounds, check for tubing obstruction.
9. Attach your nasal cannula or oxygen mask to the oxygen supply tubing.
10.If water level drops below the minimum level marking on
the Bubble Humidier add more water.
11.Empty and replace the water in Bubble Humidier daily.
7600 Bubble Humidier- 6 PSI Safety Pop-o- 3 LPM to 7 LPM
Maximum
Water Level
Pressure Relief
Valve
Oxygen Source
Oxygen
Outlet
Port
Diuser
Minimum
Water level
A
Oxygen Source
B
Oxygen Source
Oxygen
Tubing
To Patient

800-433-2797 www.Sun-Med.com
User Guide
Cleaning Instructions
1. Every 14 days wash the Bubble Humidier with warm soapy water. Use
a non-scented, lotion free liquid dish detergent. If you use tap water in
your Bubble Humidier, clean the Bubble Humidier every 3 days to help
prevent buildup of mineral deposits. Do not use bleach or
ammonia solutions to clean your device.
2. Rinse the Bubble Humidier thoroughly with clean water.
3. After cleaning the device, visually inspect to ensure
that it is clean. Repeat cleaning if necessary.
4. Replace the Bubble Humidier every 90 days (3 months),
or sooner if unable to remove mineral deposits by cleaning.
WARNING
Leaks may partially or fully reduce the oxygen being delivered.
Note
Using ow rates outside the recommend range of 3 LPM to
7 LPM and a source pressure of 7 psi may aect the function
of the safety pop-o valve.
UG-10002 Rev 1
Your setup may vary slightly depending on what system you use for your oxygen source.
7600 Bubble Humidier Home Use Cont.
7600 Bubble Humidier- 6 PSI Safety Pop-o- 3 LPM to 7 LPM