SUNMED Bubble Humidifier Home Use 7100 User manual

800-433-2797 www.Sun-Med.com
User Guide 7100 Bubble Humidier Home Use
The 7100 Bubble Humidier is a disposable, single-patient
use device for use in health care facilities and home care. The
humidier is used to provide additional humidity to oxygen
therapy for ow rates at 2 to 5 LPM. The Bubble Humidier has
a 3 PSI safety Pop-O valve, which sounds and releases excess
pressure if the oxygen tubing becomes blocked.
Product Use
1. Wash your hands and remove the Bubble Humidier
from packaging.
2. Use sterile, distilled or boiled tap water. If using boiled tap
water, cool water to room temperature before adding to the
Bubble Humidier.
3. Unscrew the lid and add water to the maximum level marking
(290 mL) located on the side of the bottle.
4. Replace the lid. Ensure that the threads are properly aligned
and that the lid is screwed on tight.
5. Attach the Bubble Humidier to an oxygen source, e.g.
owmeter, oxygen concentrator or liquid tank.
6. Test for leaks. Turn the ow to 3 LPM and block the oxygen
outlet port on the Bubble Humidier (1). A sound should emit
within 5 seconds. If there is no sound, check the lid and other
connections for leaks. Repeat the leak test.
7. Attach the oxygen supply tubing to the oxygen outlet port (2)
and adjust oxygen ow to the prescribed setting.
8. Check for bubbles in the water. If there are no bubbles check
for leaks. If the device sounds, check for tubing obstruction.
9. Apply your nasal cannula or oxygen mask.
10. If water level drops below the minimum level marking on
the Bubble Humidier add more water.
11. Empty and replace the water in Bubble Humidier daily.
3 PSI Safety Pop-O- 2 LPM to 5 LPM
Please read and follow the Instruction for Use
provided with product before using the bubble humidier.
Maximum
Water Level
Pressure Relief
Valve
Oxygen Source
Oxygen
Outlet
Port
Diuser
Minimum
Water level
1
Oxygen Source
2
Oxygen Source
Oxygen
Tubing
To Patient

800-433-2797 www.Sun-Med.com
User Guide
Cleaning Instructions
1. Every 14 days wash the Bubble Humidier with warm soapy
water. Use a non-scented, lotion free liquid dish detergent.
If you use tap water in your Bubble Humidier, clean the
Bubble Humidier every 3 days to help prevent buildup of
mineral deposits. Do not use bleach or ammonia solutions
to clean your device.
2. Rinse the Bubble Humidier thoroughly with clean water.
3. After cleaning the device, visually inspect to ensure that
it is clean. Repeat cleaning if necessary.
4. Replace the Bubble Humidier every 90 days (3 months), or
sooner if unable to remove mineral deposits by cleaning.
WARNING
Leaks may partially or fully reduce the oxygen being delivered.
Note
Using ow rates outside the recommend range of 2 LPM to
5 LPM and a source pressure less than 5 PSI may aect the
function of the safety pop-o valve.
UG-10013 Rev1
Your setup may vary slightly depending on what system
you use for your oxygen source.
7100 Bubble Humidier Home Use
3 PSI Safety Pop-O- 2 LPM to 5 LPM
Please read and follow the Instruction for Use
provided with product before using the bubble humidier.