SunRADON Luft User manual

Quick Setup
Guide
© 2020 SunRADON; P/N 1032013, Rev C; 5 March 2020
Plug In
Plug the Lüft into a wall AC outlet.
• Keep the Lüft upright as shown above. The AC plug prongs can be
rotated 90 degrees.
• Choose a location that is draft-free (away from direct air such as air
conditioning vents), and where the Lüft can remain plugged-in and
undisturbed. Tip: Replace an existing nightlight with the Lüft.
LED
The front panel displays one of the
following default colors:
• Yellow—warning
• Red—alert
• Green—ok
• Blue—nightlight
The LED colors, warning/alert thresholds, and nightlight start and stop times are
configurable in the Lüft app for each Lüft.
Warm Up
After the Lüft is plugged in and the monitor has completed its self-test, the LED
may display yellow or red until initial stabilization is complete.
•30 minutes: Initial indoor air quality (IAQ) readings (eCO2, tVOC,
Temperature, Pressure, and Humidity) are available.
•90 minutes: First radon sensor readings are available and all six sensors start
reporting hourly.
After the first plug in, the Lüft will self-calibrate in the first three hours and then
continue to optimize over the next 7 days.

SunRADON
425-B Pineda Ct.
Melbourne, FL 32940
USA
sunradon.com
Download App
Download the Lüft app from the app store of choice, or
scan this QR code to open the app page.
Start App and Connect
1. Verify that your Wi-Fi router supports
2.4 GHz. Note the router name and
password.
2. Enable Bluetooth on your mobile
device.
iPhone only: connect your iPhone to the
Wi-Fi network to which you will connect
the Lüft in Step 4.
3. Start the Lüft app and create an account
(username and password).
4. Follow the step-by-step on-screen
setup guide.
5. When asked to select the device,
locate the 4-digit Bluetooth
identifier (BT-ID) on the packaging
or product label.
6. Assign a device name.
7. Click Connect to Wi-Fi.
The Lüft app opens and the IAQ sensor
readings are updated, when available. A
status icon appears in the connected
devices pane. The icon color indicates
device status (same colors as front LED).
Updated sensor readings are available
every six minutes. Press Refresh to load
recent sensor readings, if desired.
Visit the SunRADON Support website for additional information:
https://sunradon.com/resources-support
Home Trend Settings
More options
Add device
Connected devices Outside conditions
Refresh
Overall
status
SunRADON Support