SunStar 1EH-M-23 User manual

SWF EMBROIDERY MACHINE
How to adjust height of presser foot
[Picture 1-1]
[Picture 1-2]
1) Disassemble "Head Face Plate"
(Release five screws of head face plate.)
Refer to [Picture 1-1]
1. Adjusting height of presser foot
Refer to [Picture 1-2]
2) Release screw of presser foot holder.
1
2Release screw of presser foot holder
3
4
- screw driver
Adjust presser foot
- screw driver
Fasten screw of presser foot holder
Disassemble HEAD FACE PLATE + screw driver
(just a little bit)
[K] [HEAD]
A. Subject
1EH-M-23
work order equipment
B. Procedure
C. Instruction
JIG
No.
CD CODE No:
노루발홀더죔나사
(presser foot holder
screw)
── Ver. 2009 1st ────────────────────── SunStar Co., Ltd ─

SWF EMBROIDERY MACHINE
[Picture 1-3]
[Picture 1-4]
presser foot height jig.
Initial setting:1mm, Light fabric:under 0.7mm, Thick fabric:over 1mm
4) Fasten screw of presser foot holder to use presser foot height jig
Refer to [Picture 1-3]
3) Turning main shaft to 180 degree when you
adjust presser foot height.
Refer to [Picture1-4]
※Height of presser foot depends on Fabric.
Presser foot height Jig
1.0m
── Ver. 2009 1st ────────────────────── SunStar Co., Ltd ─