SunStar SU-M-26 User manual

SWF EMBROIDERY MACHINE
fixing screws
T-wrench or L-wrench(2,4MM)
Set the lifting slider
and replace the shaft
1.Lightly Tighten the Base Plate Fixing Screws
1) Check the position of screws inside of se uin
device. [Refer to Picture 1-1]
How to Set the Lifting Guide Shaft
1
2
Lightly tighten the base plate
[Picture 1-2]
fixing screws. [Refer to Picture 1-2]
2) Use T or L wrench (4mm) to lightly loosen the base plate
[Picture 1-1]
[F3 SEQUIN DEVICE
A. Content
SU-M-26
Order Tools Required
B. Order
C. Details
JIG /
Instruments
No.
CD CODE No:
─ Ver.2009 1st ────────────────────── SunStar Co., Ltd ─

SWF EMBROIDERY MACHINE
move the lifting slider to adjust its looseness with
the lifting guide. [Refer to Picture 2-1]
A. Replace the Lifting Guide
① Use T or L wrench (2mm) to remove the lifting shaft
guide screws from the lifting base.
② Remove and replace the lifting guide shaft.
B. Assembly
① Assemble the lifting guide with the lifting slide.
② Tighten the base plate screws.
[Picture2-1]
2. Set the Lifting Slider and
1) While the base plate fixing screw is lightly tightened,
Replace the Shaft
[Refer to Picture 2-2]
[Picture2-3]
[Picture2-2]
[ Reference ]
[A] [B]
Caution ) Improperly inserted lifting slider or bent or
broken lifting guide shaft may cause noise during the
se uin work.
Caution ) When you insert the lifting guide shaft into
the lifting base after replacing it, 'A', end of the shaft,
should point to the floor.
AB
Lifting Base
Lifting Shaft Guide
Fixing Screw
Lifting guide shaft
─ Ver.2009 1st ────────────────────── SunStar Co., Ltd ─