Super Vision International • 8210 Presidents Drive • • Orlando, Florida 32809 • • 407.857.9900 •• Fax 407.857.0050 • www.svision.com10
OPERATING INSTRUCTIONS (cont.) &
FAQ / TROUBLESHOOTING
OPERATING INSTRUCTIONS (cont.)
How to ADVANCE only the Spa Light(s) one mode and FREEZE the Pool Light(s):
With the light(s) turned ON, turn the light switch to the OFF position.
Hold the light switch at the off position for 3-5 seconds and then turn the switch back ON.
This will ADVANCE the Spa Light(s) to the next color mode while keeping the Pool Light FROZEN.
Here are two approaches to get multiple color and color mode combinations:
1. Continue to use the 3-5 second approach after the Pool and Spa lights are “out of sync” – in other words:
keep the pool light(s) FROZEN and continue to ADVANCE the spa light(s) to an interesting color mode of your
liking.
OR
2. Once the pool and spa lights are “out of sync” use the 1-2 second lapse to ADVANCE both the pool and
Spa lights together one position at a time.
How to RESET the lights to the first color mode (Treasure Island):
With the light(s) turned ON, turn the light switch to the OFF position.
Hold the light switch at the OFF position for 6-9 seconds and then turn the light switch back ON.
The light(s) will flash green, blue & red before initiating first color mode (Treasure Island).
MEMORY FEATURE:
If the light is OFF for 10 seconds or more and turned back ON, it will return to the last color mode used. NOTE:
The light will always come ON as white light for 13 seconds for safety purposes before initiating the “memory
feature”. DO NOT ATTEMPT TO CHANGE MODES DURING THIS TIME.
FAQ / TROUBLESHOOTING:
The light is white for around 13 seconds then goes to the last color used. This is a safety feature built
into the “Memory Feature.” Nothing is wrong with the light. NOTE: YOU CANNOT CHANGE MODES DUR-
ING THE FIRST 13 SECONDS OF TURNING ON THE LIGHT.
Nothing happens when I turn the switch off and back on to change color modes on my SaVi Pool Light
(applies to pool lights ONLY, SaVi-PL-12/120). Try shortening the amount of time you have the switch in
the off position. If you have the switch off for 3-5 seconds, no change will occur. You must have the switch
off for no more than 2 seconds to change color modes for the SaVi Pool Light. Refer to the operating in-
structions for the time delay (in seconds) that the light switch should be off.
My light is glowing a reddish color. This fixture is equipped with an Automatic Shutdown Mode to protect
the light fixture if it is operated while not submerged in water. If operating temperatures exceed the normal
design temperatures expected with standard submerged installations, the light will enter the “Shutdown
Mode” where the light will power down to a lower setting and glow red. Once the light has cooled down it
will resume normal operation. If the light does not resume normal operation try resetting the light (turn the
light off for 6-9 seconds before turning back on) to see if the over-heated condition has cleared. If this does
not resolve the problem contact a service professional.
My light is not working. Check the circuit breaker and /or GFI circuit breaker. You may also keep the light
off overnight to allow all electrical charges to dissipate before turning it back on. If the light continues to not
function correctly, contact a service professional.
1.
2.
3.
1.
2.
3.
1.
2.
3.
4.
NEVER ATTEMPT TO OPEN THE LIGHT FIXTURE – THERE ARE NO SERVICEABLE PARTS IN THE
FIXTURE AND ANY ATTEMPTS TO OPEN THE FIXTURE MAY RESULT IN PERMANENT /IRREPARA-
BLE DAMAGE AND MAY CAUSE A SAFETY HAZARD IF RE-INSTALLED IN A POOL OR SPA.
WARNING
