Supermicro X9SRW-F User manual

SUPERMICR R
CONTACT INFORMATION
MNL-1319-QRG REV. 1.00
• www.supermicro.com (Email: [email protected])
• Manuals: http://www.supermicro.com/support/manuals
• Drivers & Utilities: ftp://ftp.supermicro.com
• Safety: http://www.supermicro.com/about/policies/safety_information.cfm
© 2012 Supermicro Computer Inc. All rights reserved. Reproduction of this document whether in part or in whole is strictly prohibited without Supermicro's written consent. All Trademarks are property of their respective entities. All information provided is deemed accurate at the time of printing; however, it is not guaranteed.
PACKAGE CONTENTS
(Applies to individual-pack only)
X9SRW-F
QUICK REFERENCE GUIDE REV. 1.00
• One (1) Supermicro Motherboard
• Eight (8) SATA Cables
• One (1) I/O Shield
• One (1) Quick Reference Guide
JLAN1JLAN2
14
JUIDB1
JSTBY1
1
3
JIPMB1
JI2C1
1
5
Socket R
LGA 2011
CPU
DESIGNEDIN USA
SXB2
SXB1B
1
JD1
JPWR1
1
T-SGPIO4
7
1
T-SGPIO3
7
1
T-SGPIO1
87
2
1
T-SGPIO2
87
1
JF1
1
2
19
20
JUSBKM
24
SXB1A
SAS2
SAS1
SAS3 SAS4
J17
H-HS2_2
SP1
JBT1
BD1
A
C
LED2
LE2
LE1
BT1
+
JOH1
JL1
1
R136
JVGA1
JTPM1
J26
J23
1
JCOM1
FAN5
FAN4
4
FAN3
FAN2 FAN1
JWF1
1
J4 J2 J3 J1
C241
JWP1
3
JI2C3 JI2C2
1
3
JPG1
JPB1
JP3
JPME1
JWD
JPL1
1
3
SXB1B:LEFT_WIO_MIDDLE
SXB2:RIGHT_WIO
SXB1A:LEFT_WIO_UP
WRITEPROTECT
JWP1:
USB
USB
1-2:RST
2-3:NIMI
JWD:
JI2C2/JI2C3
1-2:Enable
2-3:Disable
JPMB
OFF:NORMAL
ON:MERECOVERY
JPME1:
VGA
UID
JTPM1:TPM/PORT80
DIMM4A DIMM4B DIMM3B
DIMM3A
KB/MOUSEUSB/2/3
JTPM1:TPM/PORT80
JSTBY1:STANDBYPOWER FOR DOM
2-3:NMI
1-2:RST(DEFAULT)
JWD:WATCHDOGTIMER
JD1:
4-7:SPEAKER
1-2:PWR_LED
IPMILAN
USB/0/1
1-2:ENABLE
2-3:DISABLE
JPL2:LAN2
JPL1:LAN1
2-3:DISABLE
1-2:ENABLE
JPB1:BMC
COM1
JBT1:CMOSCLEAR
LAN2
JL1
LAN1
DIMM2B
DIMM2A
JI2C1
2-3:Disable
1-2:Enable
JOH1:OVERHEATLED
CPU
OFF:Disable
ON:Enable
2-3:DISABLE
1-2:ENABLE
:CHASSISINTRUSION
I-SATA3
I-SATA4
I-SATA2
I-SATA1
I-SATA0
I-SATA5
DIMM1B
DIMM1A
JPG1:VGA
J29
1
3
J30
1
3
CPU1
CLOSE 1st
OPEN 1st
Memory Population Guidelines
When installing memory modules, populate the DIMM slots in the following or-
der: DIMMA1, DIMMB1, DIMMC1, DIMMD1 then DIMMA2, DIMMB2, DIMMC2,
DIMMD2. Populate the blue-colored slots first.
• Always use DDR3 DIMM modules of the same size, type and speed.
• Mixed DIMM speeds can be installed. However, all DIMMs will run at the speed
of the slowest DIMM.
• The motherboard will support odd-numbered modules installed (1 ,3 ,5 ,or 7
modules). However, for best memory performance, install DIMM modules in
pairs.
Recommended Population (Balanced)
DIMMA1 DIMMB1 DIMMC1 DIMMD1 DIMMA2 DIMMB2 DIMMC2 DIMMD2 Total
2GB 2GB 4GB
2GB 2GB 2GB 2GB 8GB
2GB 2GB 2GB 2GB 2GB 2GB 12GB
2GB 2GB 2GB 2GB 2GB 2GB 2GB 2GB 16GB
Jumpers, Connectors and LED Indicators
Back Panel I/O Connectors
Memory Support
Motherboard Layout and Features
CPU Installation
Note: Graphics shown in this quick reference guide are for illustration only. Your components may or may not look exactly the same as drawings shown in this guide. Note: Refer to Chapter 1 of the User Manual for detailed information on jumpers, connectors,
and LED indicators. Note: Refer to Chapter 2 of the User Manual for detailed information on memory support and CPU/
motherboard installation instructions.
= mounting hole
Heatsink Installation Front Panel Control (JF1)
Jumpers
Connectors
LED Indicators
The X9SRW Motherboard supports up to 256GB of 1600/1333/1066/800 MHz
ECC/Non-ECC DDR3 DIMMs in eight (8) memory slots (UDIMM/RDIMM).
Note: For memory optimization, use only DIMM modules that have been validated by Supermicro.
For the latest memory updates, please refer to our website a at http://www.supermicro.com/
products/motherboard. DIMM Memory Installation
A. COM 1 G. LAN1
B. IPMI Port H. LAN2
C. USB 2.0 Port 1 I. VGA Port
D. USB 2.0 Port 0
E. USB 2.0 Port 3
F. USB 2.0 Port 2
E
A
B
C
F
D
G H I
10 UID Unit ID Switch Off (Disabled)
11, 12 JI2C3/JI2C2 SMB to PCI Slots On (Enabled)
16 JPG1 Onboard VGA Enable Pins 1-2 (On)
45 JWP1 BIOS Write Protect Pins 1-2 (Normal)
46 JPL1 LAN1 Enable Pins 1-2 (Enabled)
50 JWD Watch Dog Timer Reset Pins 1-2 (Reset)
52 JP3 BIOS Recover Pins 2-3 (Open)
54 J30 VRM SMB Data (to BMC or PCH) Pins 1-2 (BMC, Normal)
55 J29 VRM SMB Clock (to BMC or PCH) Pins 1-2 (BMC, Normal)
56 JPB1 IPMI/BMC Enable Pins 1-2 (Enabled)
57 JPME1 Intel ME Mode Select Pins 1-2 (Normal)
58 JBT1 CMOS Clear Short contact pads to clear CMOS
1 JCOM1 Back panel Serial Port Connector
2, 4 USB0/1, USB2/3 Back panel USB 2.0 ports
3 IPMI Back panel IPMI LAN Port
5, 6 JLAN1/JLAN2 Back panel LAN1 / LAN2 Ethernet Ports
7 JVGA1 Back panel VGA Port
14, 17 SXB1A, SXB1B Supemicro riser card slot (P/N RSC-R1UW-2E16)
15 SXB2 Supemicro riser card slot (P/N RSC-R1UW-E8R)
18, 19, 60, 61 I-SAS 0,1,3,2 (SATA3.0) I-SATA 3.0 ports (supports up to 6Gb/s)
20, 21 I-SATA0, I-SATA1 (SATA 3.0) Internal SATA ports (up to 6Gb/s)
22, 23, 24, 25 I-SATA 2,3,4,5 (SATA2.0) Internal SATA ports (up to 3Gb/s)
26 JSD1 SATADOM (Disk On Module) Power Connector
27 JL1 Chassis Intrusion Header
28,29,31,32,33 FAN 5,4,3,2,1 Front Panel Control Header
30 JF1
34 JPW1 24-pin Main ATX Power Connector
35 JPW2 8-pin Secondary Power Connector
37 JD1 Pwr LED / Speaker Header (Pins 4~7:Ext Speaker)
38 JPI2C1 Power Supply SMBus I2C Header
39, 40, 41, 42 T-SGPIO1~4 Serial Link General Purpose I/O Headers
43 JTPM1 Trusted Platform Module (TPM) Header
44 JSTBY1 Legacy Wake On LAN Header
47, 48 USB4/5, 8/9 Internal USB 2.0 headers
49 JIPMB1 System Management Bus Header (IPMI Slot)
51 BT1 System Battery
53 JOH1 Overheat LED/Fan Fail
59 SP1 Internal Speaker / Buzzer
8 LE2 UID LED Blue/Steady UID Switch is On
9 BD1 IPMI Heartbeat Green/Blinking IPMI is enabled
13 LED2 Standby 3.3V Power Green/Steady Standby Power
36 LE1 Power LED Green/Steady System is On/Running
DIMMA1 (Blue Slot)
DIMMA2
DIMMB1 (Blue Slot)
DIMMB2
DIMMC1 (Blue Slot)
DIMMC2
DIMMD1 (Blue Slot)
DIMMD2
CPU
Note:Themotherboard supportsupto 256GBof totalmemory. Pleaseconsultthe user'smanual
for more populating options.
Power Button
OH/Fan Fail LED
1
NIC1 LED
Reset Button
2
HDD LED
Power LED
#3~4
#1~2
Vcc
Vcc
Vcc
UID LED
Ground
Ground
1920
XX
Vcc
NIC2 LED
NMI
Ground
XX
Align Socket Keys
OPEN1st
OPEN1st
Motherboard
Screw#1 Screw#2
1
2
4
5
6
7
83
9
10
11
12
13
14
15
16
17
18
19
20 21
22 23
29 30 31 32 33
34
35
3637
38
39
40
41
42 43
44 45
46
47
48
49
24 25
26
27
28
50 51
52 53
61
55
56
57 58
60
54
59
DIMMD1
DIMMD2
DIMMC1
DIMMC2
DIMMB1
DIMMB2
DIMMA1
DIMMA2