Suptek MA2720 User manual

Installation Instruction
MA2720
UNPACKING INSTRUCTIONS
Carefully open the carton, remove contents and lay out on cardboard or
other protective surface to avoid damage.
Check package contents against the Supplied Parts List in the next page
to assure that all components were received undamaged. Do not use
damaged or defective parts.
Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow all instructions contained
herein. Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
If you don’t understand these directions or have any doubts about the
safety of the installation.
If you are uncertain about the nature of your wall, consult a qualified
installation contractor.
Do not use this product for any purpose or in any configuration not
explicitly specified in this instruction. We hereby disclaims any and all
liability for injury or damage arising from incorrect assembly, incorrect
mounting, or incorrect use of this product.
75X75
100X100 15” - 27”
13kg
(28lbs)
MAX
57-415MM
(2.25'-16.3')
VESA Pattern Bearing Range Applicable Size Profile
1：Remove the screw
shown in the figure
with a screwdriver
2：Then lift the panel
up by hand
Step 2 Removal of the panel
HC or D
Step 3 Install the TV
Step 4 Panel installation Step 5 Fix the panel
Reinstall the
screw removed
in step 2
Hang the panel into
the head-stock
G
Insert the two wire clips (E) into the
hole in the lower side of the square
tube to complete the routing. Use
the wrench (G) and wrench (F) to
adjust the tightness of the joint.
F
F
Hold the left and right sides of the TV,
can adjust the rotation about the TV.
If the rotation adjustment is too loose
or too tight, use wrench (F) to tighten
or loosen the nut on the figure shown
to control the tightness of left and right
rotation adjustment.
Step 6 The cable arrangement and the adjustment of the joint tightness
360°

55mm
50mm
10mm
55mm
4mm
Supplied Parts List
Brick wall
Wood wall
Step 1 Install the Wall Plate to the Wall
WARNING
Note: The mounting components and hardware supplied in this package are
not designed for installations to walls with steel studs or to cinder block walls.
If the hardware you need for your installation is not included, please consult
your local hardware store for proper mounting hardware for the application.
CAUTION!
This TV mount must be securely attached to the
vertical wall. If the mount is not properly
installed it may fall, resulting in possible injury
and/or damage.
Tools Required
4mm Drill Bit
Phillips Screwdriver
10mm Masonry Bit
Carpenter’s Level
（1）Bracket-I
I
A
B
I
A
（2）Plastic Anchors-A （2）Self-Drilling Screw-B （4）M4*10 Screw -C （4）M5*16 Screw-D
（1）Wrench-F （1）S5 Allen Key-G （4）5Washer-H
（2）Cable Clips-E
We hope you never have the need,but if you do,
our service is friendly and hassle-free.
:716-777-3938
:[email protected]