Sure Flame FN20 User manual
FN20
AIR MOVER
August 1, 2020, Rev: 1
SERVICE AND MAINTENANCE MANUAL
PLEASE RETAIN FOR FUTURE REFERENCE
SURE FLAME PRODUCTS
A DIVISION OF HAUL-ALL EQUIPMENT LTD.
4115 - 18 Avenue North
Lethbridge, Alberta T1H5G1
www.sureame.ca
SPECIFICATIONS
Electrical rating ½ HP 115 volts, 60 Hz, 7.2 Amp single phase
Fan rating: 5000 CFM. 20” 22° Fan blade
Weight 70 lbs
Effective: Feb 26, 2013FN20C Air Mover Parts
www.sureflame.com
1
5
6
1
2
4
7
8
3
Fan Guard
Fan Housing
20" Fan Blade Assembly
1/2 HP Motor
Switch Cover
Power Cord 72”
20 A Toggle Switch
Switch Box
FN20-51
FN20-54
2422
2431
FN20-14
WRS-108
5954
FN20-76
1
2
3
4
5
6
7
8
Ref. Part No Description
9
Strain Relief
5508
9
Effective: Feb 26, 2013FN20C Air Mover Parts
www.sureflame.com
1
5
6
1
2
4
7
8
3
Fan Guard
Fan Housing
20" Fan Blade Assembly
1/2 HP Motor
Switch Cover
Power Cord 72”
20 A Toggle Switch
Switch Box
FN20-51
FN20-54
2422
2431
FN20-14
WRS-108
5954
FN20-76
1
2
3
4
5
6
7
8
Ref. Part No Description
9
Strain Relief
5508
9
Maintenance
•Disconnect power before servicing
•Clean fan guards, motor and fan blade with cloth or compressed air. Do
not pressure wash or use cleaning chemicals.
•Visually inspect the fan blade and motor. Ensure that the fan blade is not
deformed or broken
•Reinstall fan guards after servicing
Troubleshooting Chart
FN20 AIR MOVER
Failure to comply with the precautions and instructions
provided with this air mover, can result in death, serious
bodily injury and property loss or damage from hazards
of re, explosion, impact, and/or electrical shock.
Only persons who can understand and follow the
instructions should use or service this air mover.
If you need assistance or information such as
an instruction manual, labels, etc., contact the
manufacturer.
Never use the air mover in spaces which may contain
volatile or airborne combustibles, or products such as
gasoline. Do not operate the air mover without the fan
guards.
WARNING
GENERAL HAZARD WARNING
Installation and operation
•To prevent risk of electrical short, only use this product on GFCI (Ground
Fault Circuit Interrupter) protected circuits.
•Ensure the fan is in good condition before operating. Check for damaged
or missing parts.
•Place on a at stable surface to avoid tipping over.
•Allow for at least 2 feet of clearance on the intake and output from obstacles.
•Connect the fan to an appropriate power source and turn the switch on.
•Do not move unit while in operation. Disconnect from power before doing so.
•This unit is not designed for ducting. Manufacturer is not responsible for
ducted performance.
•This unit is not intended for outdoor use or storage. Doing so may void
warranty.
