Sutcliffe Play SWD400 User manual

SWD400 Sling Shot
Installation Instructions
Sheet 1 of 2
9m
9m
Play level
950mm
750mm
800mm800mm
Concrete Required
800 x 800 x 750mm
Leave 200mm between the
concrete and play level
Chamfer all edges and
corners on the concrete
block.
Line up ground markings on
post with play level before
adding concrete
The site must be level to maintain critical dimensions.
Space requirements
Safety surface recommended 64m2.
Length of the safety perimeter 22.4m.
HIC 2.4m.
1.
2.
3.
Scale 1:200

Description Qty. Stock
Sling Shot Post 1 SWD430
Sling Shot Top 1
M12 Security Screw 8 FIX230
M12 Plain Washer 8 WSR050
M12 Anti-Shake Washer 8 WRS425
Fixing Tool 1 FIX295
Required Tools:
Tape Measure
Spirit Level
Digging Implements
Installation Procedure
Plan the final position of the play equipment ensuring there is enough space*.
Excavate the foundation hole in accordance with the drawing**.
Insert the spragging irons and install the post using the correct amount of concrete. Ensure that the
post is vertical and the ground level mark is set correctly. When the concrete has set (2-3 days) fit
the top section using M12 security screws and anti shake washers with the fixing tool supplied.
Check all the fixing bolts are tightened.
Do not allow the item to be used until the required safety surface has been installed.
Follow the maintenance instructions supplied.
* Care should be taken while installing to decrease the hazard for children.
** Care should be taken if the conditions aren’t normal.
1.
2.
3.
4.
Parts list
5.
SWD400 Sling Shot
Installation Procedure
Sheet 2 of 2

Disposal Instructions
All components should be broken down into catagories of:
1. Mild steel - all swing frames, Playzone, Toddlerzone, Teenzone activities, deck frames and springie frames.
2. Stainless Steel - all slides, mirror panels.
3. Aluminium - all Playzone and Toddlerzone posts and Playzone post caps.
4. Galavanised steel - all chains and Teenzone posts.
5. Moulded rubber products without steel centres - all Toddlerzone caps and edge details.
6. Timber - all natural timber, plywood and mdf panels.
Wherever possible these materials should be taken to specialist recycling organisations and recycled.
In some cases where composite materials are used then disposal at land fill sites is the only alternative such as:
7. Moulded rubber products encasing steel centres - all seats, deck tops, duo/dizzy disc tops.
8. High pressure laminate - all Toddlerzone, Playzone panels.
9. Steel core polypropylene rope - all scramble nets, space nets, Playzone/Toddlerzone ropes and rope
bridges.
Recommended Regular Inspection and Maintenance
Check stability of structure, tighten connections if required. Interval (days)
7 14 28 56 365
Check all uprights at ground level for corrosion and/or rot.
Replace any defective parts.
Check all painted elements for damage, rub down and repaint or
replace as required.
Check chain/ropework assemblies for wear and damage, replace
if
required.
Check rotating and pivot points for wear and smooth running
lubricate or replace if required.
Check rubber parts for wear and/or damage, replace if required.
Check tension of cables, adjust if required.
Check wear of cables replace if required.
Check slide chutes for smoothness and any foreign elements,
remove any found.
Check rubber safety surfaces for damage and poor performance,
repair or replace if required.
Check loose fill safety surfaces remove any foreign elements, rake
level and top up if required.
SWD400
Sling Shot
Maintenance Instructions
NOTE
The warranty is invalidated if these instructions are not
followed.