Syble XB-6255M User manual

Eg , Add prefix “A”
Step 1, Scan above code to enter into “add prefix ”
Step 2, Scan above code to add “prefix ”
Step 3, Scan the numeric code correspond to “A” ,
the ASCII value of A in Hexadecimal is 4 1
Refer to Appendix 1 & Appendix 2
Step 4,Scan “save” code to save(refer to
Appendix 1)
Eg , Add suffix “A”
Step 1, Scan below code to enter into “add suffix ”
Step 2, Scan below code to add “suffix”
Step 3, Scan the numeric code correspond to “A” ,
the ASCII value of A in Hexadecimal is “4” “1”
Refer to Appendix 1 & Appendix 2
Step 4, Scan “save” code to save(refer to
Appendix 1)
2D Barcode Scanner
User Manual
Factory Default
Version
Keyboard Language
Buzzer Prefix Setting
Suffix Setting
High
OFF
Low
ON Add prefix Prefix
NO: S2DZ1605V0
(1).Brand new decoding chip to read various 1D
& 2D barcodes.
(2).Advanced technology which can read.
e-payment barcodes like Ali-pay,apple-pay etc.
(3).Easy to use ,plug and play.
(4).Strong case to withstand 1.5m drop to
concrete.
RS232USB-HID(default)
Strueture chart
Cable remove:
Insert paper clip into the socket and press to
remove device cable.
Press trigger to remove device cable.
Product Feature
Basic Configuration
Interface
trigger
Interface
Paper clip socket
Interface
(1) USB-HID Mode: Factory default mode ,
automatically identify and install driver.
(2) RS232 Mode:Require special customized
RS232 cable and designated serial port APP
(Default parameters :Baud Rate 9600 Data
Bit:8bits Stop Bit :1bit Check Bit :None)
(3) USB-COM ,Required to install special
driver (Claim it from distributor).
Manual(default) Continuous
Auto-sensing
Suffix Setting
Scan Mode
USB-COM
TAB
None
CR (default)
CR & LF
USA (default) Czech
Turkey Q Turkey F
Italy
German
Spain
Franch
Suffix
Add Suffix
EnableDisable
Image Reverse

Upc-a converts EAN13 Settings
Appendix 1:
Appendix 2:
Bar code calibration bit setting
Note: Baud Rate must be same between barcode
scanner and serial port APP
Eg: Barcode Scanner default Baud Rate is 9600,
the APP must choose same Baud Rate 9600
Enable
Saved
Enable
Disable
Disable
Baud Rate