Sylvania SRCD261-B User manual

Repeat
Press to repeat the
current track. Press
twice to repeat the
entire album.
• If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
• Do not mix old and new batteries.
• Completely replace all old batteries with new ones.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
• Batteries should be recycled or disposed of as per state and local guidelines.
FEATURES AND CONTROLS
CD/Radio Boombox
User’s Guide for Model No. SRCD261-B
Important Safety Instructions
• Read these Instructions.
• Keep these Instructions.
• Heed all Warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including that produce heat.
• Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. wide blade or the third prong are provided for your safety. When the provided plug does
not into your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
• Only use attachments/accessories by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
• Use only with a cart, stand, tripod, bracket, or table by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
FCC Warnings
Warning: Changes or to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. limits are designed to provide reasonable protection against
harmful interference in a residential installation. equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Additional Warnings and Precautions
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
• WARNING: To reduce the risk of or electric shock, do not expose this apparatus to rain,
moisture, dripping, or splashing.
• CAUTION: Use of controls or adjustments or performance of procedures other than those
may result in hazardous radiation exposure.
• WARNING: Changes or to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
• WARNING: Do not place this unit directly onto furniture surfaces with any type of porous, or
sensitive As with any rubber compound made with oils, the feet could cause marks or staining
where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass
between the unit and the surface to reduce the risk of damage and/or staining.
• WARNING: Use of this unit near lighting may cause interference regarding use of the
remote. If the unit is displaying erratic behavior move away from any lighting, as it may
be the cause.
• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
• WARNING: is a danger of explosion if you attempt to charge standard Alkaline batteries in the
unit. Only use rechargeable NiMH batteries.
• WARNING: Lithium batteries, like all rechargeable batteries, are recyclable and should be recycled
or disposed of in normal household waste. Contact your local government for disposal or recycling
practices in your area. should never be incinerated since they might explode.
• WARNING: Shock hazard - Do Not Open.
• Caution and marking information is located at the rear or bottom of the apparatus.
• Objects with liquids, such as vases, shall not be placed on the apparatus.
• Mains plug is used as disconnect device and it should remain readily operable during intended
use. In order to disconnect the apparatus from the mains completely, the mains plug should be
disconnected form the mains socket outlet completely.
• Battery shall not be exposed to excessive heat such as sunshine, or the like.
• Keep new and used batteries away from children. If the battery compartment does not close securely,
stop using the product and keep it away from children.
WARNING: To reduce the risk of electric shock, do not remove cover
(or back). No user-serviceable parts inside. Refer servicing to
service personnel.
ATTENTION
CAUTION
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
This symbol indicates that this product incorporates double insulation
between hazardous mains voltage and user accessible parts.
The lightning with arrowhead symbol, within an equilateral triangle, is
intended to alert the user to the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of magnitude to
constitute a risk of electric shock to persons.
FEATURES
• CD player: CD, CD-R/RW
• AM/FM radio (direct tuning)
• Top-load disc player
• 3.5mm audio input
• Built-in AM/FM antenna
• 2 digit red LED display
• Analog volume control
• AC power input: requires an AC power cable
(included)
• DC battery power: requires 6 C batteries (not
included)
• Battery life: ~8 hours of audio
CD/Line In,
Adjust to switch between
or AM modes.
Tuning
In radio mode, turn
to adjust the AM or
FM radio station.
Volume
Turn to adjust the volume.
3.5mm Audio
Line Input
AC Power Input
Skip/Search
Press to skip
between tracks on
a loaded CD.
Press and hold to
search through the
current track.
Play/Pause
Press to play or
pause a loaded CD.
CD Door
LED Display
Stop
Press to stop a
CD during play.
Program
Press to program
the loaded CD to
play tracks in a
WARNING: DO NOT INGEST BATTERY,
CHEMICAL BURN HAZARD.

CD 3.5 MM AUDIO INPUTRADIO
Playing the Radio
1. Slide the Source Switch switch to AM or FM
radio mode.
2. Adjust the Tuning dial to tune the radio.
Radio Reception
An AM and FM antenna is built into the radio.
To improve radio reception, adjust the position
of the boombox.
POWER & BATTERY
Loading and Playing a CD
Note: This unit is not compatible with MP3 CDs.
1. Open the CD door and place a CD in the
boombox, label side facing up.
2. Close the CD door.
3. Adjust the Source Switch to CD mode.
4. Press the Play/Pause button to begin playing
the loaded disc.
Programming a CD
1. Press the Stop button to stop a loaded CD.
2. Press the Program button.
“01” will blink on the display.
3. Press the Skip/Search buttons to select a track.
4. Press the Program button to add the selected
track to the program.
5. Repeat steps 4 and 5 to program up to 20 tracks
to play in a order.
6. Press the Stop button to cancel a program.
Using the Line In
3.5 mm audio input cable not included.
1. Plug one end of a 3.5 mm audio input cable into
the Line In input on the back of the unit, and
plug the other end of the cable into the audio
output on an MP3 Player or other audio source.
2. Press the Power button to power the unit on.
3. Slide the Source Switch on the front of the unit
to Line In.
4. Audio played through the connected device will
now be heard through the speakers.
To power the unit, plug the power cord (included) into the AC Power Input on the back of the unit and a standard AC power outlet.
For battery power, this unit requires 6 C-size, batteries (not included).