Feature
Reliable & stable switch and dimming control function, control range 20M.
RF Naked Wall Mounted Remote
Parameter
Product Size
Remote
Part No. Operation Voltage Operation
Frequency
116368 3VDC 434MHz/868MHz
Remarks
RF Wireless
Wiring diagram
Dimming range 0.1-100%.
Use with power repeater to expand the output power unlimitedly.
Adjustment, match most walls mounted frame in the market.
Switch on/off of lightings slowly, without any flash, meet the comfort of human eyes.
Enable be dimmed and ON/OFF by push button after connecting receivers.
Enable to control 1 zones separately, each zone can be set endless receivers, each
receiver maximally be controlled by 8 different remotes.
71.5
71.5
46.34
Part No. Iuput Voltage Remarks
Current
103504 12-36VDC Constant voltage
4x(60-180)W
4x5A
Output
112694 12-36VDC Constant voltage
4x(96-288)W4x8A
Receiver
116291 12-36VDC Constant current
4x(4.2-12.6)W
4x350mA
111315 12-36VDC Constant current
4x(8.4-25.2)W4x700mA
Power Supply
12-36VDC
LN
110V-230VAC
white
103504
LED CONTROLLER
1234
Learning Key
Please pair remote and receiver, after finishing connecting receivers with LED lights correctly, base on diagram
above.
1) Press shortly the learning Key on the receiver,then push the rotary button .Once successfully learn, the LED
lights will blink on the receiver. Do the same for the other receivers if you use them, you can add as many
optional receivers as you want.
2) Short push rotary button to switch ON/OFF
Adjust dim brightness by the rotary button from left to right 0.1-100%
Adjust dim brightness by the rotary button from right to left 100-0.1%
Operation
Safety & Warnings
1) The product shall be installed and serviced by a qualified person.
2) IP20.Please avoid the sun and rain. When installed outdoors, please ensure it is mounted in a water proof
enclosure.
3) Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
4) Please check if the output voltage of any LED power supplies used comply with the working voltage of the
product.
5) Never connect any cables while power is on and always assure correct connections to avoid short circuits
before switching on.
6)
7) For update information please consult your supplier.
Please ensure that the cable is secured tightly in the connector
