Entering a Code (PowerScan)
4. Press either the CH+ or CH-
button repeatedly until the device
switches on. The CH+ button
searches up in the code list; the
CH– button searches down.
5. When the device turns on, press
and release the SELECT button
to store the new code and exit.
To exit without setting the code,
press the CLEAR Button.
Note: If you press CH+ or CH– again
after the device turns on, the device
will not be programmed; you will
need to repeat steps 1-5 again.
6. As a test, press VOL+ or VOL–
button. If the device responds, no
further programming is required.
If the device does not respond,
repeat steps 1-5.
Note: If your device does not
respond after trying all codes avail-
able in the code list, this remote may
not support your device. Contact
Customer Service for assistance.
Reminder: If you find your device,
e.g. TV, is not fully controllable by
the remote control, you may have
set the code number incorrectly or
there may be some newer models of
devices that have not been entered in
the code list.
8
