Tabata ReefTourer SNORKELING FLOAT User manual

SNORKELING FLOAT
REVERSIBLE
TOP
BOTTOM
AGE4+
Inflatable snorkeling float, featuring two (2) large,
molded handles, and reversible top and bottom.
Can be used in pool, ocean, or lake!
Compatible with
Viewing Bucket for Snorkeling
(Sold Separately)

For Customer Service: Tabata USA, Inc.
Toll Free [phone]
• Please be sure to use with parental supervision for children’s safety.
• Please do not use in the following conditions:
Strong Water Current · High Waves · Deep Water · Slippery Surfaces
• Make sure to inflate with the appropriate amount of air before use. If the Snorkeling Float is
filled with enough air, it is normal to see some wrinkles on the circumference.
• The float material may soften when placed under hot sunlight for a long period of time.
• When inflating the float, be sure not to over inflate.
• The air stopper has a double structure of a plug and a valve. Please be sure to insert the plug
firmly inside the valve.
• When it becomes difficult to insert the plug, please apply little bit of water around the plug.
• If you put too much air, the air plug may pop out.
• Wash thoroughly with fresh water after use. Shake off gently to dry off most of the moisture.
• Do not keep inside a car, a trunk, or other places under high temperature.
• Do not jump on the float.
• The Snorkel Float is not a lifeboat or life saving device.
• If you’re using for the first time, please practice several times in a small pool or water area.
• Contact with sharp objects such as a rocky corner, pile, gravel shell fragments, glass pieces,
metal pieces and wood pieces may puncture the body of the float, causing it to deflate.
• Keep away from any fire object such as cigarettes and lighters.
• Avoid using high-pressure air pump.
• Do not put head or hips in the viewing hole of the float.
Material: Float and Handles (PVC)
Size: 35.5 inch x 31.0 inch (90 cm x 77 cm)
Handling and Care
How to Install/Remove Viewing Bucket (RA0506)
Viewing Bucket for Snorkeling
(RA0506 - Sold Separately)
Installation: Before inflating the Snorkel Float, place the Viewing Bucket
inside the viewing hole until the lens surface is flush with the bottom side
of the float.
Remove: After deflating the Snorkel Float, remove the Viewing Bucket
from the viewing hole completely.