TaiShan TQ3.25TH User manual

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
Installation of Competition Elastic Balanced
Basketball Stand
TQ3.25TH

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
1) The equipment can only be used indoors;
2) The equipment is only suitable for basketball training, basketball competitions,
basketball fitness and entertainment;
3) Equipment is strictly prohibited to climb;
4) It is forbidden to use by children under 10 years old;
5) It is strictly forbidden to use sharp objects to hit the backboard and protective
cover;
6) It is strictly forbidden to hang the body on the hoop;
7) Equipment installation and commissioning must be guided by professionals from
the manufacturer;
8) The equipment is strictly prohibited to be used during the debugging process;
9) Abnormal noises or obvious loose parts during the use of the equipment should be
stopped immediately;
10) During the folding process of the equipment, it is strictly forbidden to enter
under the extension arm, or enter between the pull rod and the base;
11) Before using the equipment, check whether all parts of the equipment are in
good condition and tightly locked, otherwise it should not be used;
12) Before using the equipment, warm up sufficiently to prevent injury. If you feel
obvious pain or discomfort during use, please do not continue to use it to avoid
further injury;
13) Do not use heavy objects to hit the surface of the equipment, and do not use

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
sharp objects to scratch the equipment;
14) Do not use liquids other than neutral detergent and water to wipe the metal
coating surface of the equipment;
15) Do not place heavy objects on the surface of the equipment for a long time;
16) The equipment protective cover is formed by splicing multiple pieces of jackets,
which may cause color difference, and slight color difference is normal;
17) When using, pay attention to the operation according to the warning signs of the
product identification;
18) This product is manufactured in accordance with the requirements of the
International Basketball Federation (FIBA), but the equipment that meets the
International Basketball Federation (FIBA) standards does not mean that any risk is
eliminated. The user has not ned or is not under the supervision of the coach Injuries
caused by the use of equipment shall be borne by the user.
This product can be applied to indoor basketball. The equipment is equipped
with safety protection pads, which is highly safe; the basketball stand is folded
by springs, and can be moved after folding, with a standard 24-second timer
and signal light strip, which can be used for basketball sports; the product is
composed of parts as shown.

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
Unit：mm
Figure 1 Composition of elastically balanced basketball stand for competition

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
Product Parameter：
1) Arm length: 3250mm;
2) Basket height: 3050mm;
3) Basket diameter: 450mm;
4) The maximum weight of the basket: 320kg;
5) Backboard size: 1800mm×1050;
6) Backboard type: tempered glass backboard;
7) The thickness of the front protective cover: 100mm;
8) Thickness of the arm protection cover: 35mm;
9) Diameter of walking wheel: 150mm;
10)Total weight: about 1400kg
Installation Notes
When the product leaves the factory, the overall assembly has been completed. In
order to facilitate transportation and removal of the backboard, basket, backboard
connector and 24-second timer, the overall basketball stand is in a folded state,
which can realize the overall movement of the basketball stand, as shown in Figure
2.

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
Unit：mm
Figure 2 The folding diagram of the Elastic Balanced Basketball Stand
Product Parameter：
1) Length of boom: 3256mm;
2) Basket height: 2750mm;
3) Basket diameter: 450mm;
4) The maximum weight of the basket: 320kg;
5) Backboard size: 1800mm×10501050mm;
6) Backboard type: tempered glass backboard, tempered glass backboard;
7) Thickness of wall protection cover: 100mm;
8) The thickness of the arm protection cover: 25mmmm:
9) Diameter of walking wheel: 200mm;
10) Total weight: about 2000kg.

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
Installation Steps:
1) As shown in Figure 3, use the ④hexagon socket screw M10×80, ⑤flat
washer 10 and ⑥non-metallic insert lock nut M10 to install the ②backboard
and ③basket to the ①extension arm;
Figure 3 Backboard and basket installation
As shown in Figure 4, use ③hex socket head screw M10×30, ④spring washer
10, ⑤flat washer to fix the ②backboard connector with ①ohm plate on the
extension arm. At this time, the ohm plate is not locked and can be Notch
movement.
Figure 4 Installation of ohm board and backboard connector

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
3) As shown in Figure 5, use ③hex socket flat head screw M12×30, ④elastic
washer 12, ⑤flat washer 12 to lock the ②backboard connecting ear plate and
①backboard connector, use ⑥hex socket head screw M10×20, ⑦elastic
washer 10, ⑧flat washer 10 lock the backboard connecting ear plate and ⑨
backboard, and lock the ohm plate to the extension arm;
Figure 5 Backboard connector and backboard connection ear plate installation
4) As shown in Figure 6, use ①hex socket flat head screw M10×30, ②elastic
washer 10, ③flat washer 10 to lock the ④24 second timer on the ⑤extension
arm.
Figure 6 24 second timer installation

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
5) Fasten the outrigger protective cover to the front end of the outrigger with a
hook and loop fastener;
6) Unfolding and folding of the arm:
1. When unfolding, at least two people push up the rear post until the rear post is
vertical to the ground. During the process, the base of the basketball stand will
then rotate upward and land. After unfolding, use a hook-type wrench to lock the
adjusting sleeve; use the hexagon socket flat head screw M8×20 to install the
front pillar protective cover on the basketball stand, and all the other protective
covers are connected to the basketball stand base with buckles, and finally
②Place the protective sleeve insert into the vacant position, as shown in Figure
Figure 7 Sheath installation
2) Contrary to the unfolding process, first remove the protective cover inserts
from the front protective cover; then remove the protective covers on both sides
and stick them to the base (as far as possible to ensure that the front protective
cover will not interfere with it after being folded); use a hook Type a wrench to

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
loosen the adjustment sleeve; at least two people pull
the rear post backwards to fold the extension arm until the pin can penetrate into
the adjustment sleeve hole and can be moved after being firmly inserted.
7) Basketball stand placement and debugging:
1. As shown in Figure 8, the dotted line represents the ground, and the width of
50mm is the field end line. Place the basketball stand on the center line of the
length of the court, adjust the position of the basketball stand so that the distance
between the protective sleeve and the outer side of the end line is 2000mm;
Unit：mm
Figure 8 Placement of basketball hoop

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
As shown in Figure 9, use a hook wrench to loosen the two lock nuts ①and ③
in the figure, adjust the adjustment bolts shown in the figure below ②, so that
the height of the basket is 3050±6mm, and lock the lock nuts after completion;
Figure 9 Basketball frame adjustment
3. As shown in Figure 9, loosen the screws ④,⑤,⑦shown in the figure, and
adjust the ⑥,⑧screws to make the basket level with the ground and the
backboard perpendicular to the ground. Tighten all screws after adjustment, and
replace the arm protection cover.
Instructions for use
This product is specially designed for indoor basketball games and training.
maintenance:
1) During the use of the elastically balanced basketball stand for the game,
check whether all the connecting parts of the product are loose or falling off

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
regularly, and fasten or replace it in time to ensure safe use.
2) Check the tightness of the basket spring every three months, and lock the
spring if it is loose.
3) After the equipment has been used for one year, it should be inspected and
maintained by professionals before use.
Warranty
1) Since the date of leaving the factory, the warranty period of the elastic balance
basketball stand for competition is 1 year.
2) The nets are vulnerable parts and are not covered by the warranty;
3) Damage to the equipment surface painting caused by scratches or bumps is
not covered by the warranty.
4) The damage to the equipment caused by improper use and failure to perform
maintenance as required shall be borne by the user.
5) Provide lifetime free technical support and paid maintenance services for
equipment beyond the warranty period.

Shandong Taishan Sports Equipment Co.,Ltd
Web : www.taishansports.cn
Tools and spare parts
Item
Name
Specification
Amount
Note
1
Hook wrench
68-72
1
Tools
2
Allen wrench
5
1
3
Allen wrench
8
1
4
Allen wrench
12
1
5
Open-end wrench
17×19
1