− 2 −− 5 −
1
SPECIFICATIONS
Power output:
Inputs:
Controls:
GAIN
VOLUME
Tone:
BASS TREBLE
BASS−switch
DBS−cut/OFF/DBS−boost
TREBLE−switch
CUT/OFF/PRESENCE
PARAMETRIC EQUALIZER
PUNCH
Other features:
MUTE
CLIP
PEAK
Effect loops: SEND / RETURN (
Outputs: LINE PRE/POST
GROUND LIFT TUNER SPEAKERS
Protections:
Casing dimensions:
Overall dimensions:
Weight:
450W RMS / 4ohm
300W RMS / 8ohm
passive & active
− control with overload indicator.
control
and equalizer with .
Triple to reduce or boost low frequency:
Triple to reduce or boost high frequency:
for precise control of middle range:
120Hz−4kHz
button − increases sonic expression
button
power amp indicator
preamp overload indicator
XLR balanced output with switch and
circuit switch, ,
[combo speakon/jack]
short circuit, thermal overload, power overload
Forced cooling system with electronic efficiency control
[H x W x D] 66x380x180mm
[H x W x D] 66x380x205mm
3.3 kg
"MLO−system"
jack 1/4 inch)
Set VOLUME controller in optimum and then set appropriate input sensitivity by using
GAIN controller. GAIN controller should be set in a way that ensures to control the
amplifier on required level. It is necessary to remember not to allow to overload the
preamplifier while hard hitting the strings. The overload is indicated with OVERLOAD
indicator [3].
Begin with setting BASS and TREBLE controllers. If you need more bass tone
saturation, use the DBS switch. If you need to brighten the instrument color, use the
TREBLE switch.
Creating of advanced tone color is possible thanks to PARAMETRIC EQUALIZER. One
can switch on the EQUALIZER using button [7]. Using EQUALIZER you can precisely
adjust mid tones color. PARAMETRIC EQUALIZER is composed of 2 controllers −
MIDDLE and FREQUENCY. Operating with these 2 controllers, you can select proper
tone color range you want to amplify or cut out. Available tone color adjustment range
is set between 120Hz and 4kHz. It corresponds with range up to bass sounds
throughout whole mid band up to high tones. The EQUALIZER operation is described
in point 7 of the operation manual.
In order to enrich the instrument sound you are allowed to use additional sound
effects. The effect loop on the back panel with SEND and RETURN are meant for that.
A
C
D
B
SOUND CREATION
Connect the speaker cabinets which have an appropriate power and impedance
to the amplifier.
Select HORN on/off switch on the combo back panel as you wish.
Set every front panel controllers and switches on following positions:
− BASS, controllers in middle position,
− PRESENCE, PARAMETRIC EQUALIZER ON and DBS
Connect your bass guitar to amplifier INPUT, then switch on POWER button.
GAIN, TREBLE, LEVEL and VOLUME
switches in “OFF” position.
GETTING STARTED
5
6
Basic elements that make up the character of desired sound are tone color and
dynamics. Section composed of controllers BASS, TREBLE, PARAMETRIC
EQUALIZER as well as switches DBS and TREBLE is responsible for tone color.
Firstly set tone color using only BASS and TREBLE controllers and DBS and
TREBLE switches. In case when the adjustment is insufficient, use
PARAMETRIC EQUALIZER.
FIRST USING TIPS
A
B
C
D
