TCL H46F3500G User manual

72-MS280G-S03AG
2013.9.10
MS28
李紫云

液晶显示器
液晶显示器 使用显示器
显示器
显示器 使用
显示器
显示器 显示器
版本:72-MS280G-S03AG
公司维修服务部地址请咨询4008-123456
H46F3500G/H55F3500G/H65F3500G
液晶显示器使用说明书




07
08
05
01

02
产品使用注意事项
显示器
显示器
显示器
显示器
显示器
显示器
显示器
显示器
显示器 显示器
显示器
显示器 显示器
显示器 显示器
显示器
液晶
显示器

液晶显示器
中英文菜单
03

/
(以H46F3500G为例)
(以H46F3500G为例)
P
P
V
V
上/下选择键
(菜单打开时有效)
/
确认键
04

电池不得暴露在诸如日照、火烤或类似过热环境中。
7FORMAT PRESETSS.EFFECT FREEZE
SOURCE MENU
EXIT
INFO
显示器
100V-240V 显示器
显示器
显示
器
显示器 显示器
显示器 显示器
显示器
05

英文
06

H55F3500GH65F3500G H46F3500G
最大工作电流: 2.3A 1.3A 1.4A
100V-240V~ 50/60Hz 100V-240V~ 50/60Hz 100V-240V~ 50/60Hz
1058.7 627.7 56.5 1250 735 59.2
14.4 2033.5
164cm
1470 864 54.1
英文
工作温度0~40℃,工作相对湿度20%~80%(非冷凝),存储温度-20~60℃、
存储相对湿度20%~80%(非冷凝);
07

信号源
信号源
信号
08

LCD MONITOR
OPERATION MANUAL
H46F3500G/H55F3500G/H65F3500G

Getting started
EN 1

EN 2

Important information
Ensure that your domestic mains supply voltage
matches the voltage indicated on the identification
sticker located at the back of your set. Where the
mains plug or an appliance coupler is used as
disconnect device, the disconnect device shall remain
readily operable.
On certain models, the light indicator is located at the
side of the set. The absence of a light indication
at the front does not mean that the set is fully
disconnected from the mains. To disconnect the
set completely, the mains plug must be pulled out.
The set s components are sensitive to heat. The
maximum ambient temperature should not exceed
35 Celsius. Do not cover the vents at the back or
sides of the set. Leave sufficient space around
it to allow adequate ventilation. Install the appliance
away from any source of heat (fireplace, etc.) or
appliances creating strong magnetic or electric fields.
Moisture in rooms where the set is installed should
not exceed 85% humidity. Apparatus shall not be
exposed to dripping or splashing and no objects
filled with liquids, such as vases, shall be placed
on the apparatus. Moving the set from a cold place to
a warm one can cause condensation on the screen
(and on some components inside the set). Let the
condensation evaporate before switching the set
on again.
The or POWER/ button on the set or the
button on the remote control can be used to switch it
on and put it into standby mode. If you are not going
to be using the set for a lengthy period of time ,
switch it off completely by removing the plug from the
mains power socket.
During thunderstorms, we recommend that you
disconnect the set from the mains and aerial so
that it is not affected by electrical or electromagnetic
surges that could damage it. For this reason, keep
the mains and aerial sockets accessible so they
can be disconnected, if necessary.
Unplug the set immediately if you notice it giving
off a smell of burning or smoke. You must never,
under any circumstances, open the set yourself,
as you run the risk of an electric shock in doing so.
Therefore, it can break when the product is dropped
or impacted upon by other objects.
The LCD screen is a very high technology product,
giving you finely detailed pictures. Occasionally, a
few nonactive pixels may appear on the screen as
the performance of your product.
a soft cloth and mild detergent to clean the rest of the
set.
Important: Using strong detergents, alcohol-based
and abrasive products may damage the screen.
Dust the vents at the back and sides regularly. Using
solvents, abrasive or alcohol-based products could
damage the set. If an object or liquid enters the
appliance, unplug it immediately and have it checked
by an authorized engineer. Never open the appliance
yourself since this may put you at risk or damage the
appliance.
To ensure a safe installation, observe the following
safety notes:
Check that the wall can support the weight of the •
set and wall mount assembly.
Follow the mounting instructions provided with the •
wall mount. For certain models, make sure to screw
the hexagonal VESA wall mounting screw bosses
(and screws) provided with the set into the nuts for
the wall mount at the back of your set before your
wall mounting.
The set must be installed on a vertical wall.•
Make sure to use only screws suitable for the material •
of the wall.
Make sure that the set cables are placed so that •
there is not danger of tripping over them.
All other safety instructions about our sets are
also applicable here.
Handling the set on the table
Before setting up your set, make sure that
the surface you want to put the set on can support its
weight.
Do not place the set on an unstable surface (e.g.
moving shelf, very edge of a unit) and make sure that
the front of the set does not overhang the
surface it is standing on.
with high quality materials and components
which can be recycled and reused.
This symbol means that electrical and
electronic equipment, at their end-of-life,
should be disposed of separately from
lease, dispose of this equipment at your local
community
waste collection/recycling centre. In the European Union
there are separate collection systems for used electrical
and electronic product. Please, help us to conserve the
environment we live in!
WARNING
To prevent the spread of fire, keep candles or
other open flames away from this product at
all times.
Warning: This operation requires two people.
The LCD screen used in this product is made of glass.
a fixed point of blue, green or red. This does not affect
Safety
,
。
LCD screen
Care
Getting started
EN 3
Use a glass-cleaning product to clean the screen and
This product is designed and manufactured
Hanging the set on the wall

MENU (
.
Brings up the main menu or press to return to the previous menu
1. VOLUME UP/DOWN (VOL+/-)button
Increases/decreases the volume. In the menu system, they act like the right/left direction buttons on the
remote and adjust menu controls
Turns the set on or standby. (Note: for some models, the POWER button turns the set on or off.)
Note: The location and names of the function buttons and power button on the set may vary according to
the model.
SOURCE ( ) button
Press to select signal source.
Sockets
available on all models.
HDMI 1
HDMI1 and HDMI2 socket (input)
HDMI 2
or The HDMI can be used to connect a
PC with a compatible video card installed, certain DVD players or a high-definition
compatible digital satellite decoder. This socket p
(High-Definition Multimedia Interface) socket
rovides an uncompressed digital
connection that carries both video and audio data by way of an integrated mini-plug
cable.
USB socket (input)
This socket
Note: The number of USB sockets on the set may vary according to model. set
USB
AV 1 RCA audio video sockets input
Note: AV 1 IN adapter The socket can be used to connect the attached AV adapter
cable with VIDEO and AUDIO L & R IN sockets.
R
L
AUDIO
VIDEO
AV 1 IN
The AV IN sockets can be used to connect a range of equipment, including video
recorders, camcorders, decoders, satellite receivers, DVD players, or games
consoles. The VIDEO IN1 socket provides composite video connection.
button
2
POWER ( ) button
+ (
(
can be used to connect an USB device.
set
Note: The location and names of the sockets on the set may vary according to the model, and not all sockets
Getting started
EN 4
This socket is only used to update program.
3
)

Getting started
VGA socket (input)
This socket can be used to connect a computer.
VGA
AV adapter (output) socket
Note: The AV OUT adapter socket can be used to connect the attached AV
adapter cable with VIDEO and AUDIO L & R OUT sockets.
AV OUT
adapter
Note: The AV IN sockets can be used to connect a range of equipment, including video
recorders, camcorders, decoders, satellite receivers, DVD players, or games
consoles. The VIDEO IN2 socket provides composite video connection.
L
AUDIO
VIDEO
AV 2 IN
R
YPbPr component sockets (input)
Note:
Y
Pb/Cb
Pr/Cr
C OMPONENT These YPbPr sockets can be used to connect a device that has component
video sockets, such as a DVD player. The component sockets can recognize if
the device you're connecting to is Y Pb Pr compatible or Y Cb Cr compatible.
The component sockets provide excellent picture quality because the video is
separated into three separate parts.
Note: The audio input port called is shareable for AV 2 IN & COMPONENT
IN(YPbPr); Video input port is the same one as Pr/Cr of YPbPr.
Note
YPbPr is shareable.
AV 2 RCA audio + video sockets (input)
AV OUT
: Under PC signal source, the audio input port of
I N
RS232
RS232 socket
This socket can be used to control the monitor set.
EN 5

Standby / quit standby
Alphanumeric
buttons
a digit or a symbol in some functions.
SOURCE To select connected devices.
V+/- To control the volume.
To switch the sound off and back on again.
display programme information, if
available.
access the main menu; to return to the
previous menu .
confirm an entry or selection;
To navigate through the menus; to select
menu options
To navigate through the menus;
► can also be used to open the corresponding submenu.
* To select the picture format.
Note: You are recommended to use the full
screen mode. Do not use the display mode
with black bars on both sides of the picture
(such as 4:3) for long time; otherwise the
screen may be damaged permanently.
Important:
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. If the batteries in your remote
control are run down you can use the buttons on your set. In mode, t
hey have the same
functions as the corresponding buttons on the remote control. In the menus they have the following functions:
For models with OK button on the set: For models without OK button on the set:
VOL+, + or VOL ► ► VOL+, + or VOL ► ▲
VOL-, - or VOL ◄ ◄ VOL-, - or VOL ◄ ▼
MENU or MENU MENU or MENU
OK or SOURCE OK
Most of your monitor's functions are available via the menus that appear on the screen. The remote control
supplied with your set can be used to navigate through the menus and to configure all the general settings.
To return to the previous channel
EXIT exit the menu structure .
FORMAT To select the picture format .
PRESETS To select the picture mode .
S.EFFECT To select the sound mode .
FREEZE To freeze/unfreeze the picture .
Remote control functions
To enter a letter.
INFO To
MENU To
To
OK
To
EN 6
Getting started
MONITOR MONITOR
This manual suits for next models
2
Table of contents
Other TCL Monitor manuals