TEB T15 User manual

TEB WAX IRON T15
Instruction manual
Technical data:
Voltage 220 –240V ~ 50Hz, input 1000W
Temperature range 80 - 200°C
Safety notice:
Never leave the appliance unattended when it
is connected to a power source.
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved.
Keep the iron and its cord out of reach of
children aged less than 8 years when it is
connected to a power source or it is cooling
down.
The iron must be used and placed on a
stable, flat and heat-resistant surface.
Do not use the iron if it has fallen, if it
has obvious damage or if it leaks.
Do not use the thermostat as a switch.

Use:
Wax iron is used for ironing all types of
waxes onto ski and snowboard bases. The
most effective way of applying a ski wax is
to iron it to a base. Heat of the iron
opens a microporous base of skis and thus
the wax penetrates (seeps) into the
structure of the base and the base absorbs
it perfectly.
Installation:
Plug the iron to a power source. Put the
wax iron into upright position when it is
heating up. Indicator light glows red until
the desired temperature is reached. Then
the light goes off. It takes approximately
5 minutes. Never allow the electrical cord
to come into contact with the heating sole
plate of the wax iron.
All repairs including replacement of the
power cord must be done by a service
centre. Unplug the wax iron before cleaning
it. Wipe the wax iron with a damp cloth and
then wipe dry. Never immerse the wax iron
in water or other liquid.

Setting the temperature:
Setting the temperature is only a
recommendation and a kind of a guidance.
Perfect setting of the temperature requires
some tests and practice. The setting may
differ depending on where you work with the
iron or what type of a wax or skis it is.
When ironing down it is important to glide
the iron smoothly over the base.
Overheating the polyethylene base can cause
its damage, or may even cause a structural
damage of skis by disrupting solidity of
glued ski layers. The actual temperature of
the iron of about 140°C gives an
approximate ironing temperature of about
110°C that is considered as a limit where
there is no damage of the base and a good
penetration of wax is ensured as well.
Obligations of a user of an electrical
appliance:
1. When the product is marked with a symbol of crossed-
out rubbish bin, it means that the product is covered
by the Directive 2002/96/EC
2. It is prohibited to place the used appliance into
municipal waste
3. Used product must be thrown away to a recycling
centre
4. Proper way of proceeding prevents damaging effect on
the environment and human health
5. For more information on recycling centres contact
local authorities
6. Households play an important role in re-using and
recycling of used products
Producer:
TEB Český Těšín s.r.o.
Olřichovice 791
Třinec 739 61 Czech Republic
http://www.eteb.cz [email protected]