tecanno VENT ONE 100 User manual

WWW.TECANNO.DE
VENT ONE 100/125
COVER INSTALLATION
1. Vent One 100 /125 with four bolt holders
2. Vent cover with four retention bolts
Attention: To avoid contamination on the vent, it is recommended to wear fabric gloves!
retention bolts
1. 2.
Insert all four retention bolts into the four bolt holders on the valve
and gently press until the cover is flush to the valve frame.
1
To disassemble the cover: Use both index fingers to reach behind
two corners of the valve cover and press gently against the valve
frame with your thumb.
Repeat this process at the other two corners. In this way, gently pull
the retention bolts out of the holders until the cover is completely
detached from the valve housing.
Now the cover is firmly in position.
2
bolt holders
3
Vent housing and vent cover

WWW.TECANNO.DE
VENT ONE 100/125
COVER INSTALLATION