tecanno VENT THREE 100 User manual

WWW.TECANNO.DE
VENT THREE 100/125, FIVE 100, FRAME 100
INSTALLATION FILTER INSERT 100/125
1. Filter material
2. Filter ring
Insert the filter into the back of the filter ring as shown in fig. 1.
1
To replace the filter, insert a screwdriver or similar object into the
slit between the filter ring and the filter material. Then use the
screwdriver to pull the filter out of the ring.
CAUTION: This may damage the filter ring and material.
3
Insert the filter frontally into the free connecting piece of the vent
(e.g. Vent THREE) until it fits into place.
Now the cover can be installed (see instructions).
2
To disassemble the filter ring, put your hand through the ring and
use the index finger to reach behind one of the three long filter
prongs. Use your thumb and index finger to pull the prong out of the
anchor. After removing all three prongs, pull the ring out of the
vent
connecting piece. The filter ring is reusable with a replacement filter.
4
Filter und filter ring
1. 2.

WWW.TECANNO.DE
VENT THREE 100/125
VENT FIVE 100
VENT FRAME 100
INSTALLATION FILTER INSERT 100/125