TECHLIGHTING 700FJBRK Series User manual

2A
1.0
Installation Instructions for
Burk Head
700FJBRK_
1
920FJBURK
H-LVEADS OW OLTAGE
CAUTION: To reduce the risk of a burn or electric
shock during accessory installation, disconnect the
power to the fixture.
1
GP I :ENERAL RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry
locations and approved for use at any height above the
finished floor.
1A
Adjust the Fixture
ALLEN WRENCH
If installing or replacing lens accessory or replacing the
optic, remove the cover by unscrewing the Allen screw
from the top of the fixture using the provided Allen
wrench.
1
Tilt the fixture head to the desired position.
Lenses and Optics (Optional)
ALLEN SCREW

2
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2015 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
2B
Remove the retaining ring.
Install and/or replace lens or optic; ensure the optic is installed first followed by the lens. NOTE: A maximum of two
lenses can be installed.
Squeeze the retaining ring so that the two ends are touching, and then insert it into the fixture to secure the lens and optic
in place.
Reinstall the cover (reversal of step 2A).
5
2
3
4
RETAINING RING
LENS ACCESSORY
OPTIC
COVER
FIXTURE