TECHLIGHTING 700BCSIBS-CF Series User manual

1.0
Installation Instructions for
Siber Mirror Surface (Fluorescent)
700BCSIBS_-CF_
1
920BCSIBSCF
GENERAL PRODUCT INFORMATION:
This product is suitable for damp locations.
Bring power supply lines to the mirror in accordance with
local electrical codes.
This instruction shows a typical installation.
CAUTION—RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and DISCONNECT POWER TO THE
ELECTRICAL BOX.
BATH COLLECTION
Install the Hardware
Locate the studs on the wall where the mirror is going
to be mounted (Max 28-1/4" separation).
Use minimum of four slots to mount the back plate to
the studs with four screws and washers provided. Do
not drive the screws all the way in at this time.
1A
Bring the power line to one of the four circular holes on
the backplate.
While holding the back plate level and in the desired
position, tighten the four screws to secure it.
SCREW
BACKPLATE
STUD
1B
POWER LINE
2WASHER
1
2
1 1
3
4
3
4
4 4
4
2
2 2
2

2
Prepare the Fixture for Installation
Remove the six screws on side of the center housing in
the center of the pan.
Remove the center housing lid.
Remove one knockout and install the provided conduit
connector.
Install the Fixture
2A
1
2
3
KNOCKOUT
LID
3A
Feed the power line wire through the conduit connector
into the pan.
Place the four pan holes onto the four back plate
threaded rods.
THREADED
ROD
1
2
1
2
2
CONDUIT
CONNECTOR
PAN HOLE
POWER
LINE
3B
3
Mount the pan to the backplate with the provided
washers, lock washers and nuts.
NUT
3
3
3
3
2
3

3
3D
Connect the neutral power line wire to the white fixture
wire with a wire nut.
Connect the hot power line wire to the black fixture
wire with a wire nut.
Connect the fixture to a suitable ground in accordance
with local electrical codes.
POWER
LINE
WIRES
7
8
9
7
8
3E
Replace the lid onto the center housing and tighten the
screws.
10
LID
10
3C
Line up each anchor with the center of a backplate hole
and push the anchor in up to the threads.
Screw the anchors the rest of the way in with a
screwdriver.
Secure the backplate to the anchors with the screws and
washers provided.
4
5
6
6
4
ANCHOR
WASHER
SCREW
ANCHOR HOLE
ANCHOR HOLE
ANCHOR HOLE
ANCHOR HOLE

4
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
Install the Lamps and Mirror
NOTE: Use only your fingers to replace the lamp.
Use type T5 high output linear
fluorescent lamp in each socket.
Max 39 Watt
Line up the lamp pins on both ends with the opening on
the sockets.
Insert the pins all the way into the sockets and rotate
the lamp to lock it in place.
1
2
4A SOCKET
LAMP
LAMP
SOCKET
Carefully attach the mirror hinge onto the fixture and
tighten all four screws.
3
4B MIRROR HINGE
3
3
3
3