TECHNI-CONTACT BPL-20B User manual

BPL-20B
Techni-Contact Canada Ltd
H9R 1A3, T2C 5K5
www.TechniContact.com

2
Package M
1
NOTE: Read the entire instruction manual before you start installation and assembly.
WARNING
Component Checklist
Package W
ST6.3x55 (x4)
W-A
concrete anchor
W-B
(x4) D6 washer
W-C
(x4)
wall plate
A
(x1) (x2)adapter bracket
B
1. Solid Brick and Concrete Mounting
W-A
W-C
W-B
2. Installing the Adapter Brackets
D8 washer (x4)
M-C
big spacer (x4)
M-D
M8x30 (x4)
M-B
M6x30 (x4)
M-A
Top of the TV
M-A/M-B
M-C
M-D
bubble level
C
(x1)
C
C
Tighten all screws but do not over tighten.
· Position the adapter brackets as close as possible to the center of the TV.
· Screw the adapter brackets onto the TV.
Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen.
X X
√
60mm
(2.4")
60mm
2.4"( )
60mm
(2.4")
ø 10mm
(ø 3/8")
Screw the wall
plate onto the
wall
Drill pilot holes
2
Mark the exact
location of
mounting holes
1
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• This product should only be installed by someone with good mechanical ability
who has basic building experience and fully understands this manual.
• Make sure that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, telephone your local distributor for a replacement.
WARNING
Installers must verify that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.