Displays2go IPDTBL User manual

iPad IPDTBL
Assembly Instructions

iPad Podium WARNING – large
base plate is heavy
(7.5kg).
Carefully position base
plate over 8-way post
and align 4 off fixing
holes to threads of
post (ensuring the
countersunk holes are
uppermost). Insert and
tighten 4 off base plate
screws to secure.
Carefully lay assembled
base and post
horizontally on floor.
NB – If you are
not using cable
management for
charging, please
carefully stand base
and post upright and
proceed to stage 7.
2
WARNING – Dome-headed
chrome nuts behind enclosure
housing must not be adjusted.
1

Feed figure-8 head of power lead through
base until it protrudes from top of post.
4
Stand base and post upright ensuring
lead is kept clear of foot pads.
5
Plug figure-8 head into USB Power
Adapter (supplied with Apple iPad).
3

6
Position black mains cable into internal post channel and carefully slide USB
Power Adapter down below the top of the post.
Align 4 holes of aluminium plate and
acrylic podium top, with countersunk
holes uppermost, with threaded holes
in post
7

8
Loosely Insert 2 screws through aligned
diametrically opposite holes. Fully tighten
1 screw using hex key provided before
removing second screw.
Unlock the iPad enclosure by inserting
key into security lock and rotate
‘QUARTER TURN ONLY’ clockwise or
counter-clockwise through 90 degrees
which releases the locking pin. Return
key back to original position
to remove.
9
If you are not using cable
management for charging, please
proceed to stage 13.

10
Lift fascia out of enclosure. Insert cable (supplied
with Apple iPad) allowing 10cm to remain “free” at
charge/sync connector end by gently pressing into
retaining moulding.
Feed USB end of charge/
sync cable through
middle of enclosure,
below pin, so it just
protrudes from bottom
of support column.
11 12
Plug cable into USB Power
Adapter below podium top
and plate.

14
Align holes of the iPad holder to the
post fixings. Insert and tighten 2 screws
to secure. Rotate iPad holder through
90º, aligning remaining 2 holes to post
fixings. Insert and tighten final screw to
secure (in diametrically opposite hole
from tightened screw in stage 8).
Plug charge/sync cable into iPad and
place inside enclosure, gently press
all four corners of iPad down into
mouldings to hold.
NB – If you are not using cable management for charging, unlock the iPad enclosure by
inserting key into security lock and rotate ‘QUARTER TURN ONLY’ clockwise or counterclockwise
through 90 degrees which releases the locking pin. Return key back to original position to remove.
Lift fascia out of enclosure, and place iPad inside, gently pressing all four corners down into
mouldings to hold.
13

Replace fascia
and depress lock
button to secure
enclosure.
15