Tecnoinox P-ONE User manual

POS. 2
POS. 1
POS. 2
Screw self-threading
3,5x20 TPS/CR
POS. 1
A
POS. 3
Screw self-threading
3,5x13 TC/CR
DETTAGLIO A
SCALA 1 : 1
3-4mm
STEP 1
- Check the right position of the holes to fix the cover
POS.1 and the points to fix front stop POS.2
(View DRAWING 1)
20825 BARLASSINA (MI) - via Machiavelli, 16
www.tecnoinoxsrl.it - [email protected]
ASSEMBLY INSTRUCTIONS P-ONE
STEP 2
- Fix on both side of cabinet the front stop in position
POS.2 with screws self-threading 3,5x20 TPS/CR
STEP 3
- Insert the cover using holes in position POS.1
STEP 4
- Screw until a space of 3-4mm n°4 screws self-threading
3,5x13 TC/CR and n°4 washers M4 using holes in POS.3 (View
DRAWING 1)

VITE PER BLOCCAGGIO
2
1
STEP 5
- Fix the steel back components using n°4 screws self-
threading 3,5x13 TC/CR (Using holes in POS.4 of
DRAWING 2).
20825 BARLASSINA (MI) - via Machiavelli, 16
www.tecnoinoxsrl.it - [email protected]
ASSEMBLY INSTRUCTION P-ONE
STEP 6
- Fix the front side panel and fix the steel back components using
screws (M4x25 TC/CR for steel back panel or M4x10 TC/CR for wood
back side panel).
STEP 7
- Put the drawer inside the cabinet and adjust the front side panel using
the standard settings of the drawer.
STEP 8
- Insert bottom components.

COVER REGULATION
WHEEL
COVER
20825 BARLASSINA (MI) - via Machiavelli, 16
www.tecnoinoxsrl.it - [email protected]
ASSEMBLY INSTRUCTIONS P-ONE
STEP 11
- Verify the closure of the drawer: in the case it doesn't close
(probably due to a friction between bins and cover) rotate the
front screw to regulate the stop position of the cover.
STEP 10
- Insert bins.
STEP 9
- Fix rails using screws fixed before in front panel and using n°2 viti M4x16 TC/CR to fix them to the back
steel components.