Tektronix ITSRACK Installation instructions

ITSRACK Rack mount instructions
Use the following instructions with the illustration and table to assemble the
ITSRACK kit.
Item number Quantity Description
1 2 Bracket, rack slide, rear mount
22Bracket, rack, front
3 2 Bracket assembly, rack, rear mount
44Screw, machine 10-32 x.3/8 inch
54#8 Lock washer
68#8 Flat washer
74Screw, machine, 8–32 x 1/2 inch
8 4 Hex nut, 8–32
94Screw, machine, 8–32 x 3/8 inch, flat head
10 8 Screw, machine, 10–32 x 1/2 inch, pan head, Phillips,
with spring lock, 18–8 SS
11 4 #10 Washer, 18–8 stainless steel
12 8 Clip nut, 10–32 for round holes
www.tektronix.com
Copyright © Tektronix
*P071305100*
071-3051-00

ITSRACK Rack mount instructions
1. Remove the screws from the side of the instrument where you intend to install
the front and rear brackets.
2. Install the front brackets (item 2) on each side using the 8 x 32 flat head
machine screws (item 9).
3. Attach the one of the rear brackets (item 3) to the bracket slide (item 1) using
the provided hardware (items 5, 6,7, 8). Tighten the screws finger-tight.
4. Install the bracket assembly to the side of the instrument using the
10-32 screws (item 4) and #10 stainless steel washers (item 11). Tighten
the screws finger-tight.
5. Repeat steps 3 and 4 to assemble and attach the bracket assembly on the
other side of the instrument.
6. Install the instrument in the rack, adjusting the rear bracket as required.
a. Note the positions of the bracket and remove the instrument from the rack.
b. Tighten the hardware and place the instrument in the rack.
7. Secure the instrument in the rack using the machine screws (item 10) and clip
nuts (item 12) on the front and rear of the rack.
2Rack mount instructions