Tenergy TK-1700 User manual
PN 58000
User Instructions
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
Electric Kettle
Model No. TK-1700
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. Read all instructions before using.
2. Before connecting the kettle to the power supply, check that the voltage indicated on
the appliance (underside the kettle & base) corresponds with the voltage in your home. If
this is not the case, contact your dealer and stop using the kettle.
3. Do not let the cord hang over the edge of a table or counter or touch a hot surface.
4. Do not place on or near a hot gas or electric burner or in a heated oven.
5. Do not operate the appliance without anything in it to avoid damaging the heat
elements.
6. Ensure that the kettle is used on a rm and at surface out of reach of children, this
will prevent the kettle from overturning and avoid damage or injury.
7. To protect against a re, electric shock or personal injury, do not immerse cord,
electric plugs or kettle in water or other liquids.
8. While water is boiling, or just after the water has been boiled, avoid contacting with
steam from the spout.
9. Always take care to pour boiling water slowly and carefully without tipping the kettle
too fast.
10. Be careful of relling when the kettle is hot.
11. This appliance is not intended for use by persons (including children) with reduced
physical,sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
12. Close supervision is necessary when any appliance is used by or near children.
Children should be supervised to ensure that they do not play with the appliance.
13. Do not touch the hot surface. Use the handle or the button.
14. The attached base can not be used for other than intended use
15. Extreme caution must be used when moving an appliance containing hot water.
16. The appliance is not a toy. Do not let the children play it.
17. The kettle is for household use only. Do not use outdoors.
18. The use of accessories, which are not recommended by the appliance manufacturer,
may result in re, electric shock or personal injury.
19. Unplug the kettle from the outlet when not in use and before cleaning. Allow the
kettle to cool before putting on or taking off parts, and before cleaning the appliance.
20. To disconnect, turn any control to “off,” then remove plug from wall outlet.
21. Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions, or has been damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair or adjustment. If the supply cord is
damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualied person in order to avoid a hazard.
22. Do not use the appliance for other than intended use.
23. The kettle can only use with the stand provided.
24. If the kettle is overlled, boiling water may spill out.
25. Always ensure the lid is closed and do not lift it while the water is boiling. Scalding
may occur if the lid is removed during the brewing cycles.
HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
Notes On The Cord
This appliance has a polarized plug. To reduce the risk of electric shock, this plug is
intended to fit into a polarized outlet only one way. If the plug does not fit fully into
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do
not attempt to modify the plug in any way.
1. A short power-supply cord (or detached power-supply cord) is to be provided to
reduce risks resulting from becoming entangled in or tripping over a long cord.
2. Longer detachable power-supply cords or extension cords are available and may
be used if care is exercised in their use.
3. If a long detachable power-supply cords or extension cord is used,
1) The marked electrical rating of the detachable power-supply cord or extension
cord should be at least as great as the electrical rating of the appliance.
2) If the appliance is of the grounded type, the extension cord should be a
grounding-type 3 wire cord.
3) The longer cord should be arranged so that it will not drape over the counter
top or table top where it can be pulled on by children or tripped over.
Know Your Electric Kettle
Lid
Spout
Body
Lid Release
Button
Handle
WaterLevel
Gauge
On/Off Switch
(with Indicator)
Power Base
Before Using Your Kettle
If you are using the kettle for the first time, it is recommended that you should
initially clean your kettle by boiling and discarding the Maximum capacity of water.
After doing so, wipe the surface with a damp cloth. The kettle should now be
prepared for use.
NOTE: The max capacity of kettle is 1.7L.
Using Your Electric Kettle
1. Place the kettle on the flat surface. 2. To fill the kettle, remove it from the
power base.
3. open the lid by pressing the lid
release button. Fill the kettle with the
desired amount of water and close the
lid. The water level must be between
the Min and the Max level. Too little
water will cause the kettle to switch
off before the water has boiled.
NOTE: Do not fill the water over the
Max level, as water may spill out of the
spout when boiling. Ensure that the lid
is firmly in place before plugging the
power outlet.
MAX
1.7L
0.7L
MIN
4. Connect the plug into a power
outlet. Press the switch, the indicator
will light, and then the kettle will start
heating the water. The kettle will switch
off automatically once the water has
boiled. You will need to wait 30
seconds before pressing the switch
again to re-boil the water. Power may
be shut off at any time by either lifting
the power switch, or directly lifting the
kettle from the power base.
NOTE: Ensure that the switch is free of
obstructions, and the lid is firmly
closed.The kettle may not operate
correctly if the switch is obstructed or if
the lid is open.
5. Lift the kettle from the power base
and then pour the water. NOTE: Operate carefully when pouring
water from your kettle, as boiling water
may result in scalding or injury. Leave
the the lid closed while hot water is in
the kettle.
6. The kettle will not re-boil until the
switch is pressed again. The kettle may
be stored on the power base when not
in use.
NOTE: Always disconnect the power
supply when not use.
Boil-dry Protection
Should you accidentally operate the kettle without water, tthe kettle will
automatically switch off power. If this occurs, allow the kettle to cool prior to filling
with cold water and re-boiling.
Cleaning And Maintenance
Always disconnect the appliance from the power outlet and allow it to cool it down
completely before cleaning.
1. Never immerse the kettle, power cord or power base in water, or allow moisture
to contact these parts.
2. Wipe the kettle’s body with a damp cloth or cleaner.Never use rough, abrasive
or poisonous cleanser.
3. Remember to clean the filter at intervals. For easier cleaning, detach the filter by
pressing down the filter’s tab inside the kettle, and replace it after cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the
outside of the kettle to prevent damaging the finish.
4. When not in use, or in storage, the power cord may be wound under the
bottom of kettle.
Removal Of Mineral Deposits
Your kettle should be periodically descaled, as the natural minerals deposits in tap
water may form scale on the kettle’s bottom, causing efficiency loss. You can may
use the commercially available descaler with the kettle. Alternatively, you may use
the following instructions:
1. Fill the kettle with 3 cups of white vinegar, then add water so as to completely
cover the bottom of kettle. Leave the solution in the kettle overnight.
2. The next day, discard the liquid in the kettle.Filling the kettle with clean water to
the maximum level, bring to boil and then discard the water. Repeat several
times until the vinegar odor has been eliminated. Any stains remaining inside the
spout can be removed by rubbing with a damp cloth.
THANK YOU
Table of contents
