TERTEC Evolution 4G/LTE SAFE User manual

TERTEK Marine 4G/LTE TETRA SAFE
Digital Antenna Installation instructions
TERTEC Evolution
®
GmbH - Grosse strasse 42-44 - 24937 Flensburg
Tlf. [phone]
[email protected]
Vertikal
Horizontal
Reception
Combi Marine
LED color Yellow
4G/LTE Safe Yes
TETRA Safe Yes
Color Selection Red, White, Yellow
Noise figure <3,0 dB
Max. Output Level 108/104 dBµV
Power Consumption 50mA
Width 190 mm
Height 120 mm
Channel DVB-T/T2/FM/DAB/DAB+/5-12/21-60
Elements 1+ pcs.
Impedance 75 Ohm
Power Supply 12/230 volt
5 Volts from receiver Yes
Band BIV/V
Opening angle Hor. 360 degrees
Opening angle Ver. 180 degrees
Wind load 5.5 N
Frequency Range DAB 174-300Mhz
Frequency Range FM 87,5-108Mhz
Connector F-Connector
Frequency Range VHF 174-300Mhz
Frequency Range UHF 470-790Mhz
Specifications TERTEK 4G/LTE SAFE

Start by removing the old antenna, put the adapter on the mast and tighten the screw Pinol.
Important: fit F-Connector, strip antenna cable and make sure it is not shorted.
The amplifier is connected to 12 or 220 volts when connected to 12 volts
be black wire to - and the black / white wire to +.
The cable from the antenna connected to the input "ANT" with f-con connector.
There are 2 outputs for TV / radio, "TV1" and "TV2", these can
split to multiple outputs, if required.
Mount the antenna, put the cable through the hole on the side of the adapter.
When installing the antanna it is important to use Sikaflex,
to ensure atder not leaks.
Collector to extend the cable.
F-Connector fitted after the cable is pulled through the mounting surface.