The Land of Nod Cube 8-cube Bookcase User manual

1
CU BE
8-CUBE BOOKCASE
Made in Thailand - r04 Page 1 of 4
HARDWARE
COMPONENTS
Thank you for purchasing the 8 Cube Bookcase.This
page lists all the contents included in the box. Please
take the time to identify the hardware as well as the
individual components to this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
Customer Service 800.933.9904 | Latest instructions available on www.landofnod.com
20 - flat
washers
20 - spring
washers
1 - top panel 1- bottom panel
2 - side panels
(1 left, 1 right)
3 - shelves
Insert 10 wood dowels into each side panel as
shown.
2 - back
panels
1 - partition
WARNING: Adult Assembly Required
!
side panel
Missing hardware? Please call 800.933.9904 for replacements.
NOTE: Contains small parts. Keep away from small children.
TOOLS REQUIRED
phillips head screwdriver allen wrench (included)
(We recommend the use of hand tools instead of power tools)
24 - small
screws
20 - bolts
24 - wood
dowels
2 - large
screws

CU BE
8-CUBE BOOKCASE
Made in Thailand - r04 Page 2 of 4
Customer Service 800.933.9904 | Latest instructions available on www.landofnod.com
3
4
2Insert 2 wood dowels into top and bottom panel
as shown.
Fit dowels of top and bottom panel into
corresponding holes of assembled unit as shown.
Secure bottom panel with 2 large screws using a
phillips head screwdriver. Do not over tighten the
screws.
bottom
panel
top
panel
NOTE: Do not
over tighten the
screws
With the assistance of another adult, fit slots of
each shelf into corresponding slots of partition as
shown.
shelf
bottom
panel
shelf
shelf
top
panel
partition

CU BE
8-CUBE BOOKCASE
Made in Thailand - r04 Page 3 of 4
Customer Service 800.933.9904 | Latest instructions available at www.landofnod.com
5
6
Fit dowels of left and right side panel into
corresponding holes of assembled unit as
shown. Secure each side panel with 10 bolts, 10
spring washers and 10 flat washers using an
allen wrench. Do not over tighten the bolts.
left
side panel
NOTE: Do not
over tighten the
bolts
right
side panel
back
panel
With the assistance of another adult, position
assembled unit as shown. Attach each back
panel to assembly with 24 small screws using a
screwdriver.
Assembly is now complete.

For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe mounting, it is
essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Attach mounting bracket to top center of unit using 2 small screws.
B) Determine the final location of unit. Mark position on the wall, approximately 2" below the mounting bracket mounted to
the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is slightly smaller in diameter than
the anchor. Gently tap the plastic anchor until the flange of the anchor is flush with the wall.
D) Attach the mounting bracket to the wall by inserting 2 large screws through the mounting bracket and into the wall
anchor in the wall.
E) Place the unit so the mounting bracket on the back edge is allowed with the wall bracket.
F) Lace one end of the wall strap through both brackets, and into the other end of the strap.
G) Pull the strap tightly until secure.
Repeat step A-G for remaining wall mounting assembly.
NOTE: If you are unsure about your wall type or what mounting method you should use, consult a qualified
professional.
Wall mounting assembly is now complete.
A
C
D
small
screw
mounting
bracket
plastic
anchor
large
screw
wall
strap
mounting
bracket
Serious or fatal crushing injuries can occur from furniture
tip over. Use of tip-over restraints may only reduce, but
not eliminate, the risk of tip-over. To help prevent tip-over,
install tip restraint per instructions below.
WARNING
!
Missing hardware? Please call 800.933.9904 for replacements.
NOTE: Contains small parts. Keep away from small children.
MOUNTING HARDWARE
TOOLS REQUIRED
WALL MOUNTING ASSEMBLY
power drill
(for pilot holes only)
phillips head screwdriver
4 - plastic
anchors
2 - wall
straps
4 - small
screws
4 - large
screws
4 - mounting
brackets
CU BE
8-CUBE BOOKCASE
Made in Thailand - r04 Page 4 of 4
Customer Service 800.933.9904 | Latest instructions available on www.landofnod.com
WALL