The Modern Fan Company Lapa Hugger Kit User manual

MODERN FAN COMPANY
Customer Service
M-F 8am - 4pm (PST)
(ph) 888.588.3267
www.modernfan.com
(1) Identify Hugger Kit parts:
Lapa Hugger Kit- Installation instructions
Should you have any questions or difficulty installing your new fan,
please contact Modern Fan Co. customer service immediately.
Note: Power supply must be turned off prior to any contact with electrical
wires. It is recommended that a licensed electrician be hired to install your
ceiling fan.
Lapa Hugger Kit
ceiling plate
hugger canopy
(3) Using screws from step (2), attach hugger
canopy to fan body.
(2) Remove six screws around top of fan body.
Take note of two sizes of screws and locations.
Note: These instructions replace steps (2) through (9) of the Lapa Fan
Installation Instructions. However, you will need to refer to the Lapa Fan
Installation Instructions to complete your installation.
(4) Using the existing screws from your junction
box, or the machine screws from the fan hardware
package, secure the ceiling plate to ceiling junction
box. The electrical wires must be accessible
through the hole in the center of the ceiling plate.

(5) Remove two of the set screws from the ceiling
plate opposite one another and set aside for
step (7). Loosen the other two without removing
them from the plate.
loosened set screws
(6) Lift fan body and hang from ceiling plate hook.
The hook should go through one of the closed
holes in the hugger canopy.
With fan safely suspended by hook, make wire connections with wire nuts
included in fan hardware package as described in the control installation
instructions. If using the optional #003 or #004 control, the receiving unit
should be connected at this time and placed inside the hugger canopy.
hook through canopy hole
(7) Carefully lift fan off hook and align open
holes/slots on hugger canopy with the two set
screws that remain partially in the ceiling plate.
Twist the fan so the these two set screws hold it in
place. Reinstall the additional two set screws
through the closed holes in the hugger canopy and
into the ceiling plate . Tighten all four screws firmly.
Refer to the Lapa Fan Installation Instructions to
complete installation of the blades, bottom cap,
and/or the optional light.