the t.bone Lucan System CC 200 RC User manual
Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [email protected] DocID: 500229_22.10.2020
EN
Lucan System CC 200 RC
Quick start guide
This manual contains important information on the safe operation of the device.
Read and follow the safety advice and instructions given. Retain the manual for
future reference. If you pass the device on to others please include this manual.
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your lo-
cal waste disposal facility.
Safety instructions
Intended use
This device is used to convert acoustic signals into electrical ones. Any other use or
use under other operating conditions is considered to be improper and may result in
personal injury or property damage. No liability will be assumed for damages result-
ing from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are
not within reach of babies and young children. Choking hazard! Ensure
that children do not detach any small parts (e.g. knobs or the like) from the
unit. They could swallow the pieces and choke! Never let unattended chil-
dren use electrical devices.
Where to use the product
Never use the product
• in direct sunlight
• in conditions of extreme temperature or humidity
• in extremely dusty or dirty areas
• at locations where the unit can become wet
• near magnetic elds
General handling
• To prevent damage, never use force when operating the switches and controls.
• Never immerse the appliance in water. Just wipe it with a clean dry cloth. Do not use
liquid cleaners such as benzene, thinners or ammable cleaning agents.
Keep foreign substances from the unit!
Keep the device away from containers with liquids. Should any liquid get into the unit,
this could lead to its destruction or re. Be sure not to let any metal objects into the unit.
Features
• Condenser Instrument microphone
• Easy installation with dierent instrument holders for many dierent instruments
(not included)
• Flexible gooseneck for easy alignment on the instrument Incl. foam windscreen
• Detachable cable with screw contact
• 3-pin mini XLR connector for operation with t.bone wireless systems (also suita-
ble for Sirus and AKG wireless systems)
• Delivery including phantom power adapter (phantom power required for opera-
tion) and hard case (with space for one of the optional holders)
Main product
Microphone, foam windscreen, detachable cable
with screw contact, phantom power adapter
and hard case
Technical specications
Directivity: Cardioid
Frequency response: 30–20.000Hz
Sensitivity: -38dB ±2dB
Max SPL: 152dB
Signal-to-noise ratio: 71dB
Impedance: 100Ω
Distortion: <1%
Gooseneck length: 120mm
Cable length: approx. 2m
Hardcase dimensions (L×W×H): 26×13×7cm
Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [email protected] DocID: 500229_22.10.2020
Accessories and spare parts
Holder for guitar
Name: Lucan System CC 200 GH
Item no.: 500230
Microphone holder for clamping to
guitars or similar instruments with a
thickness of 73 to 120 mm
Holder for violin
Name: Lucan System CC 200 VH
Item no.: 500231
Microphone holder for clamping to
violins or similar instruments with a
thickness of 35 to 55 mm
Holder for clarinet
Name: Lucan System CC 200 CH
Item no.: 500232
Microphone holder for xing to
clarinets or similar instruments with a
strong Velcro strip up to a diameter of
65 mm
Holder for piano
Name: Lucan System CC 200 PH
Item no.: 500233
Microphone holder for attaching to
pianos or similar instruments with a
strong magnet
Multi holder
Name: Lucan System CC 200 MH
Item no.: 500235
Microphone holder for clipping to cello,
saxophone, trombone, cornet or similar
instruments up to 23 mm thick
Stand holder
Name: Lucan System CC 200 SH
Item no.: 500236
Microphone holder for screwing onto
all tripods with a standard 5/8" thread
Replacement phantom adapter
Name: Lucan System CC 200 PA
Item no.: 500242
Phantom adapter for the Lucan System
CC 200 RC; mini-XLR to XLR
Replacement cable
Name: Lucan System CC 200 CA
Item no.: 500244
Mini screw jack to mini XLR for op-
eration with t.bone wireless systems
(also suitable for Sirus and AKG wire-
less systems); length approx. 2 m
Hardcase
Name: Lucan System CC 200 BH
Item no.: 500255
Large hard case with space for all
system components (microphone,
phantom adapter, cable, 1 × holder
each GH, VH, CH, PH, MH, SH).
Dimensions (L×W×H):
33×22×7cm
Lucan System CC 200 RC
EN
Other the t.bone Microphone manuals
