thomann Construction Kit1 User manual

Glockenspiel Construction Kit1
EN
 Kit for children
Beginner instrument
Pitch range: c3 - g4
Sound bars in Boomwhackers colours
on a birch plywood base plate
incl. wooden beater
Required material:
glue/all-purpose adhesive,
nails 1.4 mm × 13 mm
Dimensions (W × H × D):
320 mm × 32 mm × 130 mm
Weight: 0.5 kg
1 × wooden base plate
1 × clip-on bar
1 × holding bar
2 × felt strips
12 × coloured sound bars
1 × wooden beater
Scope of supply
1. Apply glue or all-purpose adhesive on
both wooden bars on the base plate.
Mounting
2. Attach the clip-on bar with the round
nubs on the upper wooden bar and
the holding bar with the oblong nubs
flush on the lower wooden bar.
Ensure that the nubs are placed on the
outsides of the wooden bars.
Let the glue dry.

For the transport and protective packaging, environmentally
friendly materials have been chosen that can be supplied to normal
recycling. Ensure that plastic bags, packaging, etc. are properly
disposed of. Do not just dispose of these materials with your
normal household waste, but make sure that they are collected for
recycling. Please follow the notes and markings on the packaging.
Ensure that plastic bags, packaging, etc. are disposed of properly and are
not within reach of babies and young children. Choking hazard!
Risk of injury! When using a hammer, pay attention not to squeeze your
ngers/hands.
Thomann GmbH · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de
DocID: 517489_18.05.2021
3.
4.
Fix the clip-on and holdings bars
beginning from the outside with 7 - 10 nails
each evenly on the wooden bars.
Ensure that you fix the nails
between the nubs.
Apply the glue or all-purpose adhesive on
the clip-on and holding bars.
5. Attach the felt strips on the inside flush
on top of the clip-on and holding bars.
Cut off the excess of the felt strips using
scissors or a knife and let the glue or
all-purpose adhesive dry for at least
one hour.
6. After the drying time you can place
the sound bars.
Clip the oblong holes of the sound bars
on the nubs of the clip-on bar and put
the sound bars with the round holes
between the nubs of the holding bar.