Thomas Dudley KINETIC User manual

1KINETIC QUICK INSTALLATION GUIDE
This is the quick installation and setup guide for Kinetic.
Select Kinetic mounting option below.
abc
Pipe Mounted
Solenoid Cable
Not Required
(Battery ONLY)
Remote Mounted
On Pattress Box
(Not Supplied)
Cable Required
(Battery and/or
Mains Powered)
Flush Mounted
Solenoid Cable
Required
(Battery and/or
Mains Powered)
1KINETIC QUICK INSTALLATION GUIDE Continued
IMPORTANT: Ensure water supply is off
before installing the Kinetic valve.
IMPORTANT: If the Kinetic is to
be mains powered, it must be
tted with a 3amp fused spur.
MIN
20mm
bc
Solenoid is
reversible
Flow
direction
Below 1.5 bar
pressure remove
ow restrictor
Bezel cutting
template
located at
the back of
instructions
booklet
Use provided self-
adhesive spacers if
required
c
a
b
S/N: XXXX
230v~
50Hz
1.5W
®
www.thomasdudley.co.uk
© 2016 Thomas Dudley Ltd
IMPORTANT: Ensure that the
wires are in the correct position.
Brown to ‘+’ & blue to ’-’

®
Buzzer
Test
Stop Fill/
Hygiene
Button
PIR
IMPORTANT: Ensure water supply is turned on before setting up the Kinetic
IMPORTANT: The Kinetic keypad will lockout after 30mins of inactivity. To lock/unlock
press and hold the setup & test buttons for 3 seconds. Refer to booklet for further details
Steady Flashing
Setting The Residual Water Level & Fill Time
Repeat steps
1-5 after
urinal stops
ushing
6
Press Stop
5
Wait 5
Seconds
4
Press Setup
1
Wait For Urinal
To START Flush
3
Press Start
2
2KINETIC QUICK SETUP GUIDE
Walk Test
Walk Test
3
Exit
4
Urinal Starts
Flushing
2
Press Economy
Max 60mins Max 40mins
Press Hygiene
Press Test
1
Mode Select
Red/
Green
Light
Setup
Start Fill/
Economy
Button
13276 Iss A
© 2016 Thomas Dudley Ltd
0121 557 5345
0121 530 7000 [e-mail] www.thomasdudley.co.uk
www