Thor’s Drone World LIFTHOR RC PRO PLUS User manual

by Thor’s Drone World
User’s Manual
Utility mount for DJI RC PRO PLUS
PLUS

Congratulations
on your new
Utility mount for DJI RC PRO PLUS

A. LifThor RC PRO PLUS Utility Mount
B. Pre-Installed Quick release bracket
C. Tripod Knob screw (¼”-20)
D. 3x Hex Keys
E. HDMI 4K High Speed cable
F. Wrench
G. 4 x Replacement screws (M2.5 x8)
H. Mounting screws for quick release (female) plate* if needed
Content:
A.
B.
C.
D.
E.
F.
G.
H.

Your LifThor RC PRO PLUS comes with a pre-installed quick release
bracket for it to be installed on any Tripod device / StrapThor® - body
tripod or similar devices. Press the red button to release the female
plate and mount it to your tripod. We have provided 2 x mounting
screws (1/4”-20 x 3/8”) in case needed.
Pre-Installed Quick Release bracket

How to mount:
Remove the extended utility arm from the base of the mount by
unscrewing the 3 screws located on the rear with one of the provided
hex keys.
Base mount /
Tripod mount
Utility arm

Remove the screws from the small brackets located at the rear of
the base mount with the smallest hex key provided.

Align the controller support stand with the LifThor
RC PRO PLUS mount, as shown. The back plate has
indentations to provide a secure grip to the stand.

Screw the small brackets back in place. We
recommend placing all four screws before
tightening them for an even grip

Re-attach the extended utility arm to the base of the mount.
Once again, place all 3 screws before tightening them, starting with
the bottom screw.
bottom
screw 1st.

Now, your LifThor RC PRO PLUS mount is properly installed.
To access the DJI RC PRO PLUS battery bay there is no need
to unmount it. The LifThor mount is cleverly designed for you
to fold backwards the controller to access the batteries as
shown in the pictures.
*If needed you can
tighten / loosen the
hinge with the (bigger)
hex key and wrench
provided.

How to mount an additional monitor
(or any other utility / device)
To set the angle of the utility mount use the provided
(big) Hex Key and wrench to tighten it in place

Use the ¼”-20 Tripod knob screw
provided to secure the monitor
*(or any other utility) by
threading the knob through the
middle hole of the top plate
*If needed use a
6mm washer

We recommend the
use of a Quick
Release Bracket for
convenience.
* Sold separately

www.lifthor.com