Thor’s Drone World LIF THOR Freya User manual

by Thor’s Drone World
User’s Manual
Utility mount for DJI RC2

Index
1. What’s included.
2. How to Mount the LifThor Freya to your RC2
3. Secondary Monitor set up
4. Tablet or Smart Phone set up
5. How to connect your RC2 with your tablet
(Apple or Android)
6. How to mount the LifThor Freya on a tripod
7. How to use a lanyard with your LifThor Freya
8. Other recommended accessories for DJI RC2

Content
A.
B.
C.
D.
E.
A. LifThor Freya Utility Mount
B. (2x) 2.5x8mm screws
C. ¼”-20 Knob screw
D. Universal phone / tablet clamp
E. Hex Key
F. Wrench
G. Philip screwdriver
H. Type C - HDMI 4K High Speed cable (40cms)
H.
G.
F.

How to mount:
Unscrew the (2x) thumb screws located on the back
of the mount to remove the back piece.
back
Lower plate

Align the controller with the mount’s lower plate
to get access to the controller’s mounting points.
Hold it in place by using the (2x) 2.5x8mm
screws, leave it loosely for now.

Re-attach the back piece with the (2x)
thumb screws - not too tight since you will
still need to be able to align properly the
mount to the RC.

Make sure the mount is properly aligned and positioned between the
middle of the antennas. If you are having trouble aligning the mount
release more pressure of the screws

Once the mount is properly aligned,
tighten all 4 screws to keep the mount in place.

If needed, to adjust the angle of the utility mount you can loosen it
up using the hex key and wrench provided.

How to mount a HDMI monitor
Utility mount
Using the (¼”-20) knob screw provided, screw the monitor in place
through the top opening of the utility mount and secure it tightly.
Connect your RC2
Controller with the
monitor using the Cable
provided.