Thor’s Drone World LIFTHOR SC PRO ENTERPRISE COMBO User manual

by Thor’s Drone World
User’s Manual
Utility mount for DJI SC PRO ENTERPRISE / MATRICE 300

Congratulations
on your new
Utility mount for
DJI Smart Controller
ENTERPRISE /
MATRICE 300

Utility
Mount
Content:
(3x)USB 2.0
ConnecThor Cables
-Lightning
-Micro USB
-Type C
Tablet clamp
Compatible with 7.9” up to
13” devices
HDMI Cable
Hex Key / Allen Key
Screwdriver
4x Screws
(M2.5 x 8)
Tripod Knob
(¼”-20 ½”)
Wrench

How to assemble:
Remove the protective sticker from your Smart Controller to accesses
the screw points

Align the mount with your Smart Controller to secure it in
place with the (4x) screws provided. Make sure to place
all 4 screws before tightening them properly

To have better access of the rear screws loosen
up the top part of the utility mount with the hex
key and wrench provided. Remember to tighten
it back to lock its position once you have
mounted the Monitor / Tablet

Now your utility mount is properly installed!

Use the provided tripod
knob to secure a monitor in
place* by threading the
knob through the middle
hole of the top plate.
We recommend the
use of a quick release
bracket for
convenience.
- sold separately

OR mount the tablet clamp to
use in conjunction with a tablet
by tightening the tripod knob
through the middle hole on the
top plate to secure it in place*
*If needed use a
6mm washer

The clamp has two
mechanisms to ensure
your tablet sit secure
and in place.
The first mechanism is
the ratchet part, to
adjust to the size of your
tablet. We recommend
setting it a little smaller
(1” / 2.5cm) than the
actual size of the tablet
for a tighter, secure fit.
Once you have
selected the right height
lock the ratchet in place
by sliding the lock
downwards.
Lock

Place the tablet in landscape mode by pulling the spring
mechanism upwards and release it to secure the tablet in place.
You can adjust the top clamp tabs, if needed, to avoid pressing
on any buttons
*Scan the QR code
with your phone for
a video tutorial

Scan the QR code, by
opening the camera
app on your smart
phone or tablet
device.
Point your camera at
the QR code.
Tap the banner that
appears on your
device to open the
tutorial video in
YouTube

The tablet clamp is compatible with most small tablets like iPad
Mini or similar up to larger tablets like the iPad Pro 12.9” and
everything in between

www.lifthor.com