Tiffany SM710 Owner's manual

PRODUCT USE, CARE AND SERVICE
INSTRUCTIONS
Tiffany
Slushie Maker
Model: SM710
READ AND SAVE THESE INSTRUCTIONS

BEFORE FIRST USE
Read and follow all the instructions in this “Use and Care” even if you feel you are familiar with the product, and
find a place to keep it handy for future reference.
Your attention is drawn particularly to the sections concerning “IMPORTANT SAFEGUARDS”, "FOR YOUR
SAFETY", and the “SERVICE” statements.
For your convenience record the complete model number (located on the product identification plate) and the date
you received the product, together with your purchase receipt and attach to the warranty and service information.
Retain in the event that warranty service is required.
NOTE: The rating of this product (as marked on the product identification plate) is based on specific loading tests.
Normal use or the use of other recommended attachments may draw significantly less power.
IMPORTANT SAFEGUARDS
When using any electrically powered product, basic safety precautions should always be followed,
including the following:
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT.
WARNING - to reduce the risk of fire, electrical shock or injury to persons or property:
Always operate the product from a power source of the same voltage, frequency and rating as indicated on the
product identification plate.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not operate any product with a damaged cord or plug, or after the product malfunctions, or is dropped or
appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or
replacement.
Do not twist, kink or wrap the power cord around the appliance, as this may cause the insulation to weaken
and split, particularly where it enters the unit.
To reduce the risk of electric shock, do not immerse or expose the product or flexible cord to rain, moisture or
any liquid other than those necessary for correct operation of the product.
This product should not be used in the immediate vicinity of water, such as bathtub, washbowls, swimming
pool etc. where the likelihood of immersion or splashing could occur.
Do not use the product outdoors, or expose to rain or moisture.
Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified
technician or service person.
Do not immerse the motor base in any liquid.
Do not operate or place any part of this product on or near any hot surfaces (such as a gas or electric burner
or hotplate or in a heated oven).
Switch off and unplug from outlet when not in use, before assembling or disassembling parts and before
cleaning. Remove by grasping the plug - do not pull on the cord.

Do not let the cord hang over the edge of a table or bench or touch any hot surfaces.
Do not use the appliance for other than its intended use.
Do not leave the appliance unattended when switched on.
This product is intended for normal domestic/household use only.
READ AND SAVE THESE INSTRUCTIONS
PARTS LOCATION
1. Ice/salt inlet cap 2. Ice/salt inlet
3. Slushie container 4. Dispensing tap
5. Slushie outlet 6. Removable drip tray
7. Anti-slip feet 8. Power switch
9. Ice canister 10. Cap locking notch
11. Cap locking latch 12. Liquid inlet
13. Ice canister locking latch 14. Ice paddles
15. Ice chamber 16. Slushie paddles

ASSEMBLY INSTRUCTIONS
1. Take all the parts out of the gift box and remove all packing material.
2. Wash the slushie container, ice/salt inlet cap, lid and ice canister in warm soapy water, rinse well and dry.
NOTE:
Release the ice canister locking latches (13) and remove the ice paddles from the ice canister. Then
remove the ice chamber from the slushie paddles before washing the components Reassemble the
components in the reverse order after drying.
Avoid the use of solvents, polish, and abrasive or aerosol cleaners as they may damage surfaces of
the product.
CAUTION: DO NOT IMMERSE THE MOTOR BASE IN WATER OR ANY OTHER LIQUID.
3. Place the ice canister into the slushie container and secure the lid, ensuring that it sits on the slushie
container correctly—place the rear end of the lid first, then secure the cap by pressing the front of the lid
until it locks into place. Ensure the gear on the top of the ice canister assembly is correctly located in the
underside of the lid. Do not force the lid into place as it may be damaged or damage other components.
4. Place the motor base on a level surface and then put the slushie container on it. Please ensure the slushie
container sits firmly in place with the slushie outlet over the drip tray.
USING YOUR SLUSHIE MAKER
1. Turn the switch to “0”—off position and plug the unit into the power outlet.
2. Turn the switch to “1”—on position and slowly pour the chilled drink mixture into the slushie container
through the liquid inlet. You will see the drink mixture being churned by the slushie paddles.
NOTE:
Do not pour more than 1000ml (to the Max Fill line marked on the slushie container) of drink mixture
into slushie container.
Use CHILLED soft drinks, fruit juice or drink mixture to make slushie faster.
Soft drinks work best in slushie maker.
Diet soft drinks will not work in slushie maker.
3. Remove the ice/salt inlet cap and add ice cubes through the ice/salt inlet to half fill the canister then using
the ice/salt inlet cap as a measuring cup, add one cup of rock salt to the ice.
Note: Coarse sea salt may be substituted for the rock salt.
4. Add more ice to the canister until ice reaches approximately 25mm below the top of the ice canister and
add another cup of rock salt.
5. Pour a small cup of water (approximately 50ml) over the top of the ice and rock salt and put the cap back
on the lid.
6. Leave the unit running for 10-15 minutes to make your desired consistency slushie.
NOTE: Do not operate the unit for more than 20 minutes. Allow the machine to cool down for at least 10
minutes before making another batch.
7. Check the ice and rock salt mixture through the ice/salt inlet after 5 minutes. If the mixture has melted,
add a few more ice blocks and a half cap of rock salt to the canister. Do not overfill the canister.
8. When the slushie reaches your desired consistency, turn off the power switch, place a cup under the
slushie outlet and turn the dispensing tap clockwise to “Pour”position to get the slushie.
Note: When peaks begin to form in the slushie mixture adjacent to the paddles it is a good indication that
the mixture has reached a good consistency.

CLEANING AND MAITENANCE:
1. Turn off the power switch and remove the plug from power supply socket.
2. Remove the lid, ice canister and discard any remaining ice and salt.
3. Disassemble the ice canister according to ASSEMBLY INSTRUCTIONS above.
4. Wash the slushie container, ice/salt inlet cap, lid and ice canister parts in warm soapy water, rinse well
and dry.
5. Wipe the motor base with damp soft cloth and dry.
CAUTION:
DO NOT IMMERSE THE MOTOR BASE IN WATER OR ANY OTHER LIQUID.
DO NOT WASH ANY PART IN THE DISHWASHER.
STORAGE
Ensure all parts are washed and thoroughly dried before reassembly. Save the unit in a cool, dry place.
FOR YOUR SAFETY
Always operate the product in accordance with the above instructions.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
CAUTION: To reduce the risk of electric shock, do not disassemble the product. No user serviceable parts inside.
Refer all servicing to an authorized service facility.
SERVICE
In some products, the replacement by the user of the flexible cord is not intended. Special tools are required to
disassemble the product or replace the power cord. Return the complete product to the place of purchase or
the address noted in the warranty card for inspection, repair or replacement.
G
G. .A A. .F F. . C Co on nt tr ro ol l ( (S Sa al le es s) ) P Pt ty y. . L Lt td d. ., ,
1
18 8 T Ta ar ra as s A Av ve en nu ue e ( (P PO O B Bo ox x 1 19 9) ), ,
A
Al lt to on na a N No or rt th h, ,
V
Vi ic ct to or ri ia a, , 3 30 02 25 5
T
Te el l: : 1 13 30 00 0 6 65 59 9 4 48 89 9
READ AND SAVE THESE INSTRUCTIONS

RECIPES