Timago JMC-C 5105 User manual

1
INSTRUCTIONS FOR USE
Wall shower bench with legs, foldable
Product code: JMC-C 5105
1. Characteristics
Shower bench consists of seat made of durable PVC, height adjustable
legs with anti-sliding rubber tips and wallplate. Owing to push button
height adjustment, the bench can be adjusted patient’s height. The
bench is made of higher strength materials resistant to humidity.
The set includes:
•seat with wallplate and adjustable legs with anti-sliding tips
Elements of the bench:
a. wallplate
b. mounting openings
c. seat
d. handle
e. height adjustment – locking pin
f. anti-sliding tips
2. Application
The shower bench is ancillary equipment which helps the user to
perform hygienic activities. The chair is recommended to people with
reduced mobility which prevents or hinders the unassisted
performance of daily living activities. The bench can be used in the
shower, in the bath, in bathrooms and other humid rooms at home and
in hospitals.
3. Assembly
Step 1. Before assembly, adjust the bench to user’s height. To adjust
the height, press locking pin, select appropriate height, and lock the

2
position of the tubes relative to each other with the use of locking pin.
The legs are adjustable in 2.5 cm increments.
Note! The pins must be set on the same level in each leg.
Step 2. Decide and mark the place on the wall where wallplate will be
fixed.
Step 3. Bore assembly holes in the wall using drill at the appropriate
height and width.
Step 4. Screw wallplate to the wall.
Note! Due to danger, do not use wall shower bench when legs are
unstable.
4. Technical data
Seat dimensions 29-48 cm
Height adjustment 38-53 cm
Weight 2.58 kg
Maximum capacity 135 kg
5. Notes
Timago International Group does not bear responsibility of improper
use of the wall shower bench, failure to comply safety regulations
and misuse.
6. Maintenance
•Clean the shower chair regularly using only water, sponge and
mild detergents for plastic materials such as soap. Dry thoroughly.
•Do not use for cleaning: strong detergents, abrasive agents,
bleach, petrol or solvents (it may cause frame damage, visible
defects and in consequence - loss of warranty rights).
•Systematically please check:
-tightening of screws
-condition of locking pins
-condition of tubes (if cracks)

3
It is recommended to check the rubber tips regularly. In case of
worn-out, replace the tips with the new ones.
7. Storage and transport conditions
Device should not be exposed to direct sunlight, water or moisture.
8. Warranty information
All products distributed by our company are covered by a warranty, the
terms of which are described in the warranty card available on our
website. Please contact the retailer from whom you purchased the
product. Please, keep in mind that for warranty purposes, the proof of
purchase (receipt or invoice) should be retained
9. Labels
Reference
number
Manufacturer
LOT number Manufacture date
Serial number Medical device
Note
Please read the
instruction
The manufacturer checked for compliance with
essential medical devices requirements.
Our complete line of products is available from our distributors.
Learn more at: www.timago.com. Thank you for choosing Timago!

4
Timago International Group
Spółka z o.o. i Spółka – Spółka komandytowa
ul. Karpacka 24/12
43-316 Bielsko-Biała, Polska
T.: [phone]
F.: [phone]
E.: [e-mail]
Rev. II, date 20.05.2021