Timago JMC- C 54012 User manual

1
INSTRUCTIONS FOR USE
Bath grab bars 30 cm /40 cm /45cm /60 cm /80 cm
Product code: JMC-C 54012 /16 /18 /24 /32
1. Characteristics
Bath grab bars are made of powder coated steel frame. Owing to the
application of several protective layers, they are resistant to humidity.
The grab bars can be assembled vertically or horizontally.
The set includes:
a. handle
b. screws – 6 pcs
c. rawlplug – 6 pcs
d. rubber washers
2. Application
Bath grab bar is ancillary equipment which facilitates tilting to erect
position and keeping balance. The grab bars are recommended to
people with reduced mobility which prevents or hinders the unassisted
performance of daily living activities. The bath grab bars can be used in
the shower, in the bath, in bathrooms and other humid rooms at home
and in hospitals.
3. Assembly and general recommendations for use
Note! Follow the information contained in this manual while assembly.
Users with reduced mobility may need help from a third person who
has appropriate skills.
Note! Do not use the grab bars when you notice any visible or
perceptible damage (e.g. crack) as this may cause an accident.
Step 1. Decide and mark the place on the wall where bars will be fixed.
Step 2. Bore assembly holes in the wall using drill at the appropriate
height and width.

2
Step 3. Fix the bars with the use of screws and rawlplugs.
4. Technical data
Product code
Width
Weight
JMC- C 54012
30 cm
0.45 kg
JMC-C 54016
40 cm
0.53 kg
JMC-C 54018
45 cm
0.60 kg
JMC-C 54024
60 cm
0.69 kg
JMC-C 54032
80 cm
0.80 kg
Maximum capacity: 100 kg
5. Notes
Timago International Group does not bear responsibility of improper
use of the bath grab bars, failure to comply safety regulations and
misuse.
6. Maintenance
•Clean the shower chair regularly using only water, sponge and
mild detergents such as soap. Dry thoroughly.
•Do not use for cleaning: strong detergents, abrasive agents,
bleach, petrol or solvents (it may cause frame damage, visible
defects and in consequence - loss of warranty rights).
•At least once every three months check:
-tightening of screws
-condition of tubes (if cracks)
7. Storage and transport conditions
Device should not be exposed to direct sunlight, water or moisture.
8. Warranty information
All products distributed by our company are covered by a warranty, the
terms of which are described in the warranty card available on our
website. Please contact the retailer from whom you purchased the

3
product. Please, keep in mind that for warranty purposes, the proof of
purchase (receipt or invoice) should be retained
9. Labels
Reference
number
Manufacturer
LOT number Manufacture date
Serial number Medical device
Note
Please read the
instruction
The manufacturer checked for compliance with
essential medical devices requirements.
Our complete line of products is available from our distributors.
Learn more at: www.timago.com. Thank you for choosing Timago!
Timago International Group
Spółka z o.o. i Spółka – Spółka komandytowa
ul. Karpacka 24/12
43-316 Bielsko-Biała, Polska
T.: [phone]
F.: [phone]
E.: [e-mail]
Rev. II, date 20.05.2021